User manual SONY VAIO PCGA-PRV1 DATASHEET

[. . . ] Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. [. . . ] 32 times speed operations with real time error correction. Equipped with audio line output and headphones jack for audio CD playback. Note: The CDU701 is not equipped with an ADPCM audio cir cuitr y required to suppor t CD-R OM XA and CD-I compatib le audio modes. In addition, the unit does not support the CD-I graphic decoding function; it has to be pr ovided b y the system. To access data on CD-R OM discs, the appr opriate de vice driver and MSCDEX (supplied with the host adapter) must be installed in your computer when the OS is MS-DOS/Windo ws 3. The application software y ou need f or using the data on a CD-R OM disc depends on the type and f ormat of the tar get data. See the man ual supplied with y our CD-R OM disc f or instructions. To use the CD-R OM drive unit, the f ollo wing components are required: · 3 Volume control Controls the volume level of sound output from the headphones jack 2 . 4 Busy indicator This amber indicator lights or flashes to indicate one of the following unit conditions. Steady lit: TOC (table of contents) read, seek data read, or audio playback in progress. 5 Emergency eject hole Used to open the disc drawer manually when neither the eject button 6 a software command works. Note: Both Micr osoft CD-R OM Extensions (MSCDEX) or equiv alent and Son y's De vice Driver are required to run the CDU701 under the MS-DOS and Windo ws 3. Theref ore , prior to loading the installation diskette , make sure that the MSCDEX is in the DOS director y of y our har d disk drive (C:\DOS). 2), you ma y need to obtain the software fr om y our PC dealer if y ou do not ha ve it. At the DOS Pr ompt A: (Drive A active), >A:\ Load the diskette into the flopp >A:\install and then, press the Enter ke y. After installation, the f ollo wing lines are ad and A UTOEXEC. Note: When the drive is set up in ver tical position, use the disc loc ks to pre vent y our disc fr om falling. 4 Gently push the drawer or press the eject button to close the drawer. The drive may begin reading the Table of Contents (TOC) data when it accepts the disc. The busy indicator lights up in amber while the drive is reading the TOC. For subsequent drive operations, follow the instructions provided with the application software you are using. note: The b usy indicator sta ys lit in amber if: ­ the disc is not properly placed on the loading tray ­ amalfunctionoccurs. [. . . ] Note: The eject b utton does not w ­ the software you are using S Opening the drawer manually in an emergency Y can open the dra ou wer man uall y when it fails to come out b y means of the eject b utton or software commands. 2 Insert a pointed object, such as a paper clip, into the emergency After remo ving a disc fr om the drive unit, qualified ser vice per sonnel. The disc tra y has f our disc loc ks that pre vent the disc fr when the drive is set up in ver tical position. Note: When the drive is used in horizontal position, lock the disc. [. . . ]