User manual SONY PCLK-MD2

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. [. . . ] Match the orientation of the connector with that of the serial connector on your computer when plugging the cable. Do not insert any metal objects into the connection jacks. Connection for recording from a CD in the CD-ROM drive The connections below are possible if your computer has the LINE OUT jack or PHONES jack. Connection for listening to the MD deck output from your computer's speakers Connect the LINE IN jack on your computer to the LINE (ANALOG) OUT jacks on the MD deck using an optional audio connecting cord* (pin-plug ~ stereo miniplug). When using this connection, open the "Volume Control" window, click "Options" to display the "Properties" window, click "Recording, " and then check "Line In" in "Show the following volume controls. Use a monaural (2P) mini-plug cord (either supplied with your CD player or purchased optionally) to connect a Sony CD player equipped with CONTROL A1 (or CONTROL A1) jacks directly to the MD deck. This allows you to control the CD player as well as the MD deck from your computer. When controlling the MD deck from the computer, make sure that only one CD player is connected and that the CD player's command mode is set to "1. " The audio cord connection (either digital or analog) should also be made between the CD player and MD deck. This manual explains how to use the basic functions of MD Editor 2. for additional information about software functions and operations , refer to the on-line manual in the supplied CD-ROM. The latest information about this software can be found in the "Readme. Before you use the on-line manual, Adobe Acrobat Reader (Adobe Systems Incorporated) must be installed in your computer. Operating instructions in other languages can be found in the on-line manual (page 10). Click the "Index" tab in the above search topic dialog box, and the table of contents disappear and a list of keywords are displayed. To search for a keyword, enter the word by which you want to search or scroll the list of keywords. To view the explanation on a keyword, select the keyword from the list of keywords and click "Display. Use this procedure to install this software onto your computer's hard disc. If the dialog box does not appear, double-click "Install" in the CDROM folder. Do not erase, move, or change its contents. 0 of PictureGear Label Maker, if an older version already exists in your computer, the older version will be overwritten by version 4. If you restarted your computer by selecting "Yes, I want to restart my computer now" in the dialog box that appeared at the end of the Label Maker installation, you should double-click "Install" in the CD-ROM folder to set up the on-line manual or install the Adobe Acrobat Reader. [. . . ] N Make sure that the power cord from the MD deck is connected to a power outlet. N Turn the power of the MD deck off and on, and then restart the MD Editor 2. N Start up another application often used and check if computer functions properly. n After uninstalling (page 14) , try re-installing (page 12). [. . . ]