User manual SONY PCM-R700

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Occupying the same position as start IDs, a program numbers allow you to locate specific tracks or play tracks in a specific order. Skip IDs indicate tracks or recorded portions that are to be skipped while playing. Skip IDs are 1 second in length (2 seconds in long-play mode). An end ID is 9 seconds in length (18 seconds in long-play mode). When an end ID is detected during playback, playback stops and the deck rewinds the tape to its beginning. If an end ID is detected during fast-forwarding, the tape stops at that point and deck becomes ready for recording from that point. You can write and erase an end ID only with the optional remote RM-D750. The OPEN/CLOSE 6, STOP p and PAUSE P buttons do not work during the writing or erasing of sub codes. Writing and erasing of sub codes and renumbering of program numbers are impossible if the record-protect hole on the DAT cassette is open (see page 11). Writing program numbers during recording Program numbers occupy the same positions as the start IDs and are determined by depending on the following conditions: When a program number is displayed The next program number rises by one above when the next start ID is written. Writing start IDs manually during recording press START ID WRITE. "ID WRITE" appears in the display for a few seconds and the start ID is written on the tape. The interval between start IDs must be more than 18 seconds (36 seconds in long-play mode). If the interval is less than 18 seconds (or 36 seconds), the deck may fail to detect the second start ID while playing a tape. Writing start IDs automatically during recording press START ID AUTO repeatedly until "AUTO" appears in the display. For details on the condition for the automatic writing of start IDs, see "Writing start IDs automatically during recording" on page 7, and "Menu Operations" on pages 24 and 25. When no program number is displayed ("--" appears instead) Program numbers are not written even when start IDs are written. To write program nunbers, rewind the tape to the nearest start ID to display the program number, and then locate the position where you want to start recording. Specifying the first program number to be assigned 1 Pause recording. 2 Press the number button(s) on the supplied remote, or turn DATA to input the first program number. During automatic start ID writing the positioning of some start IDs may be inaccurately or inappropriately positioned away from the beginning of the track. If this happens, you can reposition or erase the start IDs later (see "Accurate positioning of sub codes" on pages 21and 22, and "Erasing Sub Codes" on page 23). [. . . ] After pressing REW 0 ) PREVIOUS = /FF or / NEXT + tape stops momentarily before starting , the to move. The deck cannot be operated with the remote (supplied). The search function does not stop at the specified track. / The specified program number does not exist on the tape. [. . . ]