User manual SONY PCM-M1

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. You can return your unwanted nickel metal hydride batteries to your nearest Sony Service Center. Note: In some areas the disposal of nickel metal hydride batteries in household or business trash may be prohibited. For the Sony Service Center nearest you call 1-800-222-SONY (United States only) Caution: Do not handle damaged or leaking nickel metal hydride batteries. [. . . ] Note If a Start ID is erased, the program number which is written on the same point will be erased also. You can erase the Start IDs without erasing the contents of the existing recording. Press ) + or = 0 so that you are in the track after the Start ID you want to erase. During this step the sound will be muted. Note Writing and renumbering of the program number may not be completed successfully to a tape that has been recorded on other DAT decks and has a Start ID at the beginning. A program number is a signal which indicates the number of the program (track). The program number is written at the same time as the Start ID. When recording from the beginning of the tape The program number is written automatically from number 1 in sequential order at the same time as the Start ID. When recording from the halfway of the tape Press the ) + or = 0 button to display the program number before you begin recording. The program number is written in sequential order from the following program at the same time the Start ID is written. Renumbering the program number Renumbering is necessary for the following tapes: · On which the Start ID was written during playback. ⷠWhich has missing program numbers or duplicated program numbers because the tape is recorded from the halfway of it. ⷠWhich has a missing program number because the program number was erased at the same time a Start ID was erased on the tape. The tape will automatically rewind to the beginning of the program number that was written with the Start ID and then starts to renumber the program (tracks). " " flashes while the program number is renumbered and "RENUM" and the tape counter appears while the tape is fast forwarding to the next Start ID program (track). When the renumbering operation is completed, the recorder rewinds the tape to the beginning and stops. You can connect the tape-corder to other analog audio equipment and audio equipment with digital output. The volume cannot be adjusted with the VOL buttons of this recorder. You cannot use the POC-DA12/DA12M/ DA12S digital connecting cables with this unit. Playback with an audio equipment with digital input (Digital connection) The AVLS* function is operational when using the headphones during playback or in the recording monitor mode. The AVLS function keeps down the maximum volume to protect your ears. * Auto Volume Limiter System Note You may operate the AVLS function on both the main unit or the remote control. [. . . ] Do not use any type of abrasive pads, scouring powders or solvents such as alcohol or benzene. Using the supplied cleaning cassette 1 Insert the cleaning cassette as you would a normal DAT cassette. 2 Press the ( PLAY button, then press the p STOP button after about 10 seconds. 3 Remove the cleaning cassette without rewinding it. [. . . ]