User manual SONY PCV-R547DS

[. . . ] Notice to Users © 2000 Sony Electronics Inc. Reproduction in whole or in part without written permission is prohibited. This manual and the software described herein, in whole or in part, may not be reproduced, translated, or reduced to any machine-readable form without prior written approval. NOTICE Updates and additions to software may require an additional charge. Subscriptions to online service providers may require a fee and credit card information. [. . . ] In PCV-R547DS and PCV-R549DS, slots 2 and 3 are available. In PCV-R545DS, slots 3 and 4 are available. Some models, such as Configure-to-Order systems, may already contain installed add-in cards. To insert an add-in board Make sure you observe the proper safety precautions when you add boards to your Sony computer. See Notes on Use in the VAIO® Consumer Information Guide . Shut down your computer and turn off all peripheral devices, such as your printer. Unplug your computer and any peripheral devices. Remove the cover as described in Removing the Cover. Locate one of the available expansion slots. Remove the screw, and then remove the slot cover. Install the add-in board by plugging it into the expansion slot. Page 321 Attach any internal cables that the board requires (see the manual for the add-in board). Replace the cover and reinstall the screws as described on Replacing the Cover. Connect all peripheral devices and AC power, and then turn on the computer. Adding Memory The computer has two memory slots. For memory upgrades, use only 3. 3V 64-bit PC-100 SDRAM DIMM modules. Sony computer supplies, accessories, and peripherals can be purchased from your dealer or by contacting Sony at http://www. sony. com/accessories. To install memory Make sure you observe the proper safety precautions when you add DIMMs to your Sony computer. See Notes on Use in the VAIO® Consumer Information Guide . Shut down your computer and turn off all peripheral devices, such as your printer. Unplug your computer and any peripheral devices. Remove the cover as described in Removing the Cover. If necessary, remove any cables, add-in cards, or other components to access the DIMM sockets. Handle the DIMM only by the edges, and remove it from its anti-static package. Locate the keys on the bottom edge of the DIMM . Align the DIMM over the socket. To avoid damaging the DIMM socket, move the DIMM socket tabs slightly outward to relieve pressure. The DIMM should then click easily into place. Page 322 Firmly insert the bottom edge of the DIMM into the socket. [. . . ] If you are entitled to 90-day on-site service and if you purchased the Product in the United States and the Product is located in the United States, then you may be entitled to on-site repair service during the w arranty period, subject to certain restrictions. In all instances, how ever, prior to an on-site service call being provided, you must communicate w ith Sony sufficiently to allow it to perform initial diagnostics of your Product. Please contact SONY as set forth below for further information. With respect to all service provided, it is your responsibility to backup the contents of your hard drive, including any data you have stored or softw are you have installed on the hard drive. [. . . ]