User manual SONY PCWA-A220

[. . . ] In order to comply with FCC radio-frequency radiation exposure guidelines for an uncontrolled environment, this equipment has to be installed and operated while maintaining a minimum body to antenna distance of 20 cm. Based on continuous exposure of 30 minutes. Users are not permitted to make changes or modify the system in any way. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] Injury could result if the adapter strikes a person or fragile material, such as glass. · Keep the Access Point out of the reach of children. Unforeseeable injury could result from swallowing loose parts, etc. · Place the Access Point on a stable surface. Do not place the Access Point on wobbly or tilted surfaces. Tipping or falling could result in injury. · When using wall mounting, make sure that the wall is strong enough to support the Access Point. The Access Point could fall if the wall is not strong enough, leading to unforeseeable accidents. Further, be careful not to drop the unit or the tools used for mounting it. Doing so could result in unforeseeable accidents. · Avoid locations that are directly exposed to sunlight or heaters. · Internal overheating could result in fire or damage to the unit. · Make sure connectors are properly connected. ­ Do not insert any metallic objects inside the connectors. Short-circuiting the pins could cause fire or damage to the unit. ­ Be careful to insert connectors squarely. Crooked insertion could cause pins to shortcircuit, possibly causing fire or damage to the unit. · Use only the supplied AC adapter with your Sony Wireless LAN Access Point. To disconnect your Wireless LAN Access Point from the power supply, unplug the AC adapter. For customers in Canada · This class B digital apparatus complies with Canadian ICES-003. · Operation is subject to the following two conditions; (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. · To prevent radio interference to the licensed service, this device is intended to be operated indoors and away from windows to provide maximum shielding. Equipment (or its transmit antenna) that is installed outdoors is subject to licensing. [. . . ] · High humidity or poor ventilation. · Direct sunlight or extreme heat. · Magnetic fields (near magnets, speakers, or televisions). · Locations where the transmission of radio waves may be obstructed by metal plates or concrete walls. Mass Approximately 7 oz (Approximately 200 g) (Not including the AC adapter) Maximum connection distance Approximately 328 feet (100 m) (The maximum connection distance depends on the environment. ) Recommended number of units connected 16 units or less (number of clients) Protocol support TCP/IP Standard IEEE 802. 11b/IEEE 802. 11 (wireless connection) IEEE 802. 3 (wired connection) Operation Exposure to rapid changes in temperature or very damp environments may cause moisture to condense on internal parts. [. . . ]