User manual SONY CLIE PEGA-HS10

[. . . ] This appliance is classified as a CLASS 1 LASER product. The CLASS 1 LASER PRODUCT MARKING is located on the rear exterior. This caution label is located inside the unit. This stereo sytem is equipped with the Dolby* Btype noise reduction system. * Dolby noise reduction manufactured under licence from Dolby Laborotories Licencing Corporation. [. . . ] · To skip tracks while recording from a tape, press , or º on deck A. Deck B stands by for recording, and you can skip tracks. To resume dubbing, press on deck B. Æ . . . . . . , , , , » Æ » / / 35 1 2 3 4 1 Insert a blank tape into deck B. Press FUNCTION repeatedly until the source you want to record (e. g. , CD) appears. Press r. Deck B stands by for recording. · (for Press EDIT/DIRECTION repeatedly to select A to record on one side. Select a (or RELAY) to record on both sides. 23 Recording a CD by specifying track order -- Program Edit You can record tracks from all the CDs in the order you want. When programming, make sure the playing times for each side do not exceed the length of one side of the tape. 1 2 3 4 Place a CD and insert a blank tape into deck B. Press FUNCTION repeatedly until "CD" appears in the display. Press PLAY MODE repeatedly until "PROGRAM" appears in the display. You can vary the speed of the drums by turning the jog dial counterclockwise (for pad A) or clockwise (for pad B). To adjust the volume of the pads Press LEVEL + or ­. Note When the APPLAUSE MIX function is selected, you will not hear the drum pad during the applause. 27 Using the beat function With the beat function, you can create a variety of rhythms automatically. This effect can be used with any source, to create original recordings. POWER LEVEL +/­ jog dial To change the speed Hold down BEAT SPEED and turn the jog dial (or press BEAT SPEED +/­ on the remote) to select the speed you desire (BPM 70~140). To change the beat pattern You can select from 8 different beat patterns. Hold down BEAT SELECT and turn the jog dial (or press BEAT SELECT +/­ on the remote) to select the pattern you desire. The name of the beat pattern appears in the display. ~SAMBA n n 0 ) , , / Æ, To cancel the beat Press BEAT ON/OFF. Make sure the indicator is off. To change the beat volume Press LEVEL + or ­. Tip BEAT ON/OFF BEAT SPEED BEAT BPM SELECT CONTROL You can use the drum pads and the beat function together. Note When the APPLAUSE MIX function is selected, you will not hear the drum beat during the applause. 1 2 Press BEAT ON/OFF to make sure the indicator is off, then start playing a source. Press BPM CONTROL repeatedly to obtain the beat speed you desire. Every time you press the button a voice says, "one, two, three, four, one . . ", the speeds (BPM 70~140) are also displayed. The beat speed is memorized automatically. 3 Press BEAT ON/OFF to start the beat. Pressing BPM CONTROL lets you synchronize the beat with the source. 28 Sound Adjustment Adjusting the sound You can reinforce the bass, create a more powerful sound, and listen with headphones. POWER DBFB Notes · With some songs, the music will sound distorted when you use the DBFB system with the graphic equalizer if the bass is too strong. [. . . ] Press and hold 0 to return. continued 43 Troubleshooting (continued) Tuner Severe hum or noise ("TUNED" or "STEREO" flashes in the display. ·The signal strength is too weak. A stereo FM program cannot be received in stereo. ·Press STEREO/MONO so that "STEREO" appears. Tape Deck The tape does not record. [. . . ]