User manual SONY CLIE PEGA-UC500

[. . . ] Before operating the processor, check that the operating voltage is identical with your local power supply. This unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. If you are not going to use the processor for a long time, be sure to disconnect the processor from the wall outlet. To disconnect the AC power cord, grasp the plug itself; never pull the cord. [. . . ] Turn on the source component, the LD player for example, and start playback. Use the MASTER VOLUME on your amplifier to adjust the volume. Press again to restore the sound Press BASS BOOST to turn on the B. Press an INPUT button to select the component you want to use: To listen to or watch * In order to take full advantage of the Dolby Digital (AC-3) bass redirection circuitry, we recommend setting the sub woofer's cut off frequency as high as possible. (However, when using an amplifier with 5. The menu functions may not be available when the unit is set to the "BYPASS ON" mode. ) to the BYPASS IN jacks on the processor as described on page 6, use the function selector on that component to select the component you want to listen to ("CD" for example). This unit switches to the "BYPASS ON" mode while its POWER is set to off. Press POWER on the front panel to turn on the processor. Press INPUT SELECT < or > repeatedly to display the input for the component you want to use (or press BYPASS to display "BYPASS ON"). EXAMPLE: If you connected your LD player to the AC-3 RF INPUT, select "AC-3 RF". However, if you adjust parameters from the same menu in the BASIC mode, those settings change accordingly. For example, when you switch to the basic mode, the individual tone controls for each speaker (in the EQUALIZER menu) are preserved. However, a single adjustment to the general tone controls (in the SURROUND menu) sets all speaker equalizations to the front speaker settings. 2 Press MENU / repeatedly to select the parameter you desire from the respective menu 3 Press +/­ repeatedly to select the setting you desire. 4 Repeat steps 1 through 3 to make all necessary adjustments. The LEVEL ADJUST menu contains speaker level adjustment parameters that allow you to balance output level to each speaker. Most of these settings can also be adjusted directly using remote. When the menu mode is set to BASIC, you can select between "OFF" and "[ ] auto". When the menu mode is set to EXPAND, you can select which speaker will emit the test tone; [L]: left (front), [C]: centre, [R]: right (front), [SR]: rear right, [SL]: rear left. Push the MENU knob repeatedly to display one of the following menus: BASIC mode Initial setting is : FRONT L ___1___ R Lets you adjust the balance between the front left and right speakers. Initial setting is : REAR L ___1___ R Lets you adjust the balance between the rear left and right speakers. [. . . ] If the unit is installed in a rack, remove the unit from the rack, then try turning the power back on. If this does not correct the problem, turn off the power and consult your nearest Sony dealer. A setting used by the Dolby Pro Logic Surround mode to determine the kind of signal processing required to produce the surround effect with the speakers you have connected. The centre mode is determined automatically according to the setting of the speaker size parameters in the SP. [. . . ]