User manual SONY CLIE PEGA-UC600

[. . . ] Don't throw away the battery with general house waste, dispose of it correctly as chemical waste. A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a fuse of the same rating as the supplied one and approved by ASTA or BSI to BS1362, (i. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] While monitoring the Press and hold m/M sound (Search) during play. 2 Press and hold m/M to set the time to start play while looking at the display, then press H. You can change the displayed language if the TEXT disc has multi language capacity. When the player detects such a TEXT disc, "MULTITEXT" appears in the display. When "OVER" appears in the display, the disc has reached its end. Tracks that are only a few seconds long may be too short for monitoring. In this case, the player may not search correctly. If the player cannot display the language used in a TEXT disc, "OTHER LANG" appears in the display. /> on the remote repeatedly) until the desired language appears in the display. After a few seconds, the information appears in the selected language. You can play an entire disc or a specific track repeatedly. This player is equipped with a Multi-channel management function that sets the playback mode of the Super Audio CD by the DSD-DSP (built into the player) according to the layout or size of your speaker. To set the Multi-channel management function, select the appropriate preset playback mode (2 channel mode or Multi-channel mode), and then adjust the output level balance for each speaker (only in the case of Multi-channel mode). This features only work when you play the Super Audio CD. You may not be able to adjust the output level balance depending on the speaker layout mode that you selected. If you select "S" for the surround speakers, the bass frequencies will come from the front speakers and/or sub woofer. If the sound is noisy or the Multi-channel playback is not effective while playing a Multi-channel Super Audio CD, change the settings of the speakers concerned to "S". When you set the sub woofer to "­­" in the Multichannel mode (page 15), "SW BAL" cannot be adjusted ("NOT IN USE" appears). Similarly, "CNTR BAL" or "SURR BAL" cannot be adjusted ("NOT IN USE" appears) when you set the corresponding speaker to "­­". Example: When you select "SURR BAL" during stop mode, the test tone is output from the front speakers and surround speakers. The output level balance can be adjusted in up to 24 steps. Since fine adjustments can be made, it may be difficult to observe the movement of needle. [. . . ] Be sure that the command mode of the remote (position of the CD1/2 switch) (page 24) matches the command mode of the player (page 8). There is no sound from the SUB WOOFER jack. Select a playback mode in which the sub woofer signal is output from the SUB WOOFER jack. The mode indication is displayed with "+ SW" (page 15) when such a mode is selected. [. . . ]