User manual SONY CLIE PEGA-UC75K

[. . . ] Don't throw away the battery with general house waste, dispose of it correctly as chemical waste. A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a fuse of the same rating as the supplied one and approved by ASTA or BSI to BS1362, (i. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] Do not push the disc tray to close it in Step 5, as you may damage the player. While the disc tray is open by pressing EXCHANGE on the player /> on the remote repeatedly) until the desired language appears in the display. If the play of the current disc ends, the player stops playing. If the disc is played in 1DISC Repeat Play mode (page 13), the current disc starts playing again. In Program Play mode (page 14), only the tracks on the current disc are played. After a few seconds, the information appears in the selected language. You can locate a particular point in a track during play or play pause. You can play an entire disc or a specific track repeatedly. This function can be used with 1DISC Shuffle Play to repeat all the tracks in random order (page 14), or with Program Play to repeat all the tracks in a program (page 14). While monitoring the Press and hold m/M sound (Search) during play. 2 Press and hold m/M to set the time to start play while looking at the display, then press H. If you turn off the player, disconnect the power cord, press A OPEN/CLOSE on the player, or switch the playback layer or area, the program will be erased. If you switch the playback layer or area during Program Play, a single track only will be played back from its beginning, and then the program will be erased. If you select a playback mode other than "2ch DIRECT" or "Mch DIRECT" using the Multichannel management function, the sound distribution to the speakers will change, possibly causing a decrease in overall sound volume. If this occurs, adjust the volume with the volume control on the connected amplifier. If you change the playback mode while the player is in Multi-channel mode, the output level balance settings will be canceled. This function cannot be used during CD playback. Adjusting the output level balance of each speaker You can adjust the following items in the case of Multi-channel mode: SURR BAL The relative output level balance between the front speakers (FRONT L/R) and the surround speakers (SURR L/R) CNTR BAL The relative output level balance between the front speakers (FRONT L/R) and the center speaker (CENTER) SW BAL The relative output level balance between the front speakers (FRONT L/R) and the sub woofer (SUB WOOFER) When you set the sub woofer to "­­" in the Multichannel mode (page 16), "SW BAL" cannot be adjusted ("NOT IN USE" appears). Similarly, "CNTR BAL" or "SURR BAL" cannot be adjusted ("NOT IN USE" appears) when you set the corresponding speaker to "­­". Example: When you select "SURR BAL" during stop mode, the test tone is output from the front speakers and surround speakers. Some adjustment may not work depending on the Multi-channel mode that you selected. You cannot adjust the speaker level when "Mch DIRECT" is selected. [. . . ] If the disc is dirty with fingerprints or dust, it may lessen the quality of the audio out. Before playing, clean the disc with a cleaning cloth. Clean the disc with a soft cloth slightly moistened with water, and remove moisture with a dry cloth. Do not use solvents such as benzine, thinner, record cleaners, or anti-static spray. [. . . ]