User manual SONY CLIE PEGA-UC90

[. . . ] The model number and serial number are located on the back of the product. Record the serial number in the space provided here. Refer to the model and serial number when you call the Sony Customer Information Center. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. [. . . ] When you use the unit for the first time or when the internal battery charge is low, it is necessary to recharge the internal battery. When the internal battery is recharged, you do not need to connect the unit to the power outlet to use it. When using the unit at low temperatures (50°F (10°C) or less), connect it to the AC adaptor as the battery life tends to shorten. ⷠDo not let the battery run out when reading or writing data, as this may damage data and/or the hard disk. ⷠIf the unit is not connected to the power outlet and it fails to start even though the internal battery is not depleted, recharge the internal battery or use the AC adaptor. Depending on the operating conditions, starting the unit may demand more energy than usual from the internal battery. Indicates the remaining charge as shown below when Giga Vault is used only with the battery: 3 Lit Green: Full charge 2 Lit Green: Charge low (approx. 10 to 60% remains) If you connect the unit to your computer when the internal battery is at this level, it may not have enough remaining charge to power the unit. if this is the case , connect the AC adaptor. Blinking Red: Charge extremely low (less than 10%) · When the AC adaptor is connected and used as the power source, the three green indicators light only when the battery is fully charged. the status of the battery charge is indicated as: 3 Lit Orange: Full charge 2 Lit Orange: Charge low (approx. Your operating system detects the unit and installs the default device driver. Wait until the system informs you that the installation is complete. Windows XP opens a selection dialog box at this point. Note Connect the unit directly to a USB port of your computer when you install the device driver. Avoid connecting the unit to USB hubs or with extension cables. Access the CD-ROM with Windows Explorer or other such application, and then double-click Setup. (If you copied the contents of the CDROM to the C:\Gigavault folder on the hard disk of your computer as indicated in step 1, double-click Setup. Follow the instructions on the screen to complete the installation of the device driver. Note A device driver is necessary for each different unit that you connect to a computer. Outlined above to install device drivers for the second unit onward. Perform the following procedure before connecting the unit to your computer. [. . . ] The unit does not function properly when connected to a USB hub. The unit does not function properly when using it at the same time as other USB devices. You cannot disconnect the unit, because a message indicating that the storage device is in use appears. C If you connect the unit to a USB hub, the unit may not function properly, depending on your hub. [. . . ]