User manual SONY PFVSP3300 INSTALLATION MANUAL

[. . . ] SIGNAL PROCESSING UNIT PFV-SP3300 BACKUP POWER SUPPLY UNIT HK-PSU03 INSTALLATION MANUAL 1st Edition Serial No. 10001 and Higher (PFV-SP3300) Serial No. WARNING This manual is intended for qualified service personnel only. To reduce the risk of electric shock, fire or injury, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. [. . . ] Be sure to attach a ground wire to avoid an electric shock. PFV-SP3300 1-1 (E) 1-3. Do not block the ventilation holes of the unit. Both of the front and rear sides must be at least 20 cm away from the walls for ventilation and maintenance. The outer dimensions of PFV-SP3300 are as shown here: 380 61 ø26 550 26 440 17. 5 132. 4 375 482 Unit: mm 1-2 (E) PFV-SP3300 7 1-4. Installing/Removing Optional Power Supply Unit 1-4. Installing/Removing Optional Power Supply Unit w Before installing the backup power supply unit HK-PSU03 in PFV-SP3300, set the power switch of HK-PSU03 to the "O" position (OFF). Otherwise, deterioration of a connector which connects HK-PSU03 to PFV-SP3300 may cause a fire. Loose the four screws and remove the front panel. 3. Make sure that the power switch of the backup power supply unit HK-PSU03 is set to the "O" position (OFF). Insert HK-PSU03 into PFV-SP3300 and push it by hand as far as it will go. Secure HK-PSU03 with the two screws which is removed in step 2. Screws (with stoppers) Handle PSW 3x8 HK-PSU03 PSW 3x8 Indicator Front panel Screws (with stoppers) 2. Remove the two screws and remove the blank panel in the empty slot for the backup power supply unit. n Keep the blank panel which is removed. 6. Connect the power cord, before setting the power switch to the "I" position (ON). n If the indicator does not light, turn off the power and contact your local Sony Sales Office/Service Center. Turn off the power of the power supply unit which you want to remove. (Set the power switch to "O" position. ) 2. Unplug the power plug from the wall outlet. Remove the screws securing the power supply unit. Pull out the power supply unit from the slot using its front handle. Reinstall the front panel. PSW 3x8 PSW 3x8 Blank panel PFV-SP3300 1-3 (E) 1-5. Installing Optional Board The optional board can be installed in any empty slot of PFV-SP3300. [. . . ] Rack Mounting Procedure Explains the procedure for rack mounting by Rack Mount Kit RMM-10. n Fasten the screws at the tightening torque below. Tightening torque: 1. 2 N. m {12. 2 kgf. cm} 1. Attach the rack brackets in the side panels of the unit with the specified six screws. [. . . ]