User manual SONY PHC-ZW770L

[. . . ] --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. CAUTION You can use this player on AC power source only. When you use this player for the first time, or when you have not used it for a long time, leave it connected to AC power source for about one hour to charge the built-in backup battery for the clock, timer, preset radio stations, etc. [. . . ] 3 Press and hold the number button that you want to preset the new station on for 2 seconds. If a station cannot be preset automatically You need to preset a station with a weak signal manually. 1 Press RADIO BAND·AUTO PRESET until the band you want appears in the display. 2 Press + TUNE or TUNE ­ to set the frequency to the station you want. 3 Press and hold ENTER MEM for 2 seconds. 4 Turn MULTI JOG until the preset number (1 to 10) you want for the station flashes in the display. 5 Press ENTER MEM again. The Radio 19 Playing preset radio stations Once you've preset the stations, use MULTI JOG on the player or the number buttons on the remote to tune in to your favorite stations. RADIO BAND AUTO PRESET MULTI JOG On the remote 1 Press BAND to select the band. 2 Press the number button to tune in the stored station. 1 2 Press RADIO BAND·AUTO PRESET to select the band. Turn MULTI JOG to tune in the stored station. 20 The Radio The Audio Emphasis Selecting the audio emphasis (SOUND/MEGA BASS) SOUND You can adjust the audio emphasis of the sound you are listening to. SURROUND MEGA BASS The Audio Emphasis Selecting the sound characteristic Press SOUND to select the audio emphasis you want. Each time the button is pressed, the display changes. Choose ROCK To get powerful, clean sounds, emphasizing low and high range audio POP light, bright sounds emphasizing high and middle range audio JAZZ percussive sounds, emphasizing bass audio VOCAL the presence of vocals, stressing middle range audio Off the whole dynamic range for music such as classical music continued The Audio Emphasis 21 Selecting the audio emphasis (SOUND/MEGA BASS) (continued) Reinforcing the bass sound Press MEGA BASS. "MEGA BASS" appears in the display. To return to normal sound, press the button again. Getting the surround effect Press SURROUND. If it is lit, press STANDBY. 1 2 Tune in the radio station and insert a blank tape into the tape compartment with the side you want to record on facing you. Do the following operations by checking the display window. Tip When you receive the AM program in step 1, press z/X to check if the noise is heard. If so, press MODE to select the position that most decreases the noise. 3 Turn MULTI JOG to display "RADIO" and "REC", and press ENTER MEM. When recording from the component connected to the LINE IN jacks of the player, turn MULTI JOG to display "LINE" and "REC", and press ENTER MEM. continued The Timer 27 Timer-recording radio programs (continued) 4 Set the timer to the hour and the minutes you want to start recording. 1 Turn MULTI JOG to set the hour and press ENTER MEM. 2 Turn MULTI JOG to set the minutes, and press ENTER MEM. 5 6 Set the timer to the hour and the minutes you want to stop recording. (Do as step 4. ) Turn MULTI JOG to set the volume you want, and press ENTER MEM. Tips · To exit the standby mode, press STANDBY to make the indication disappear. · The preset settings remain until you reset them. 7 Press STANDBY. The indication lights up and the power goes off; the player enters the recording standby mode. At the preset time, the power will go on and music will fade in and the recording will start. Then music will fade out and the power will go off at the preset time, and the player will enter the standby mode again. To check/change the recording timer settings Press TIMER, then ENTER MEM. Each time you press ENTER MEM, a stored setting is displayed in the set order. [. . . ] · Place the player in a location free from vibration. · The sound may drop out or noise may be heard if the CD is recorded using a personal computer (CD-R, etc. ). · Move the player away from the TV. · If you are using the remote while listening to AM radio, noise may be heard. [. . . ]