User manual SONY PLM-A35E

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Picture/sound distortion may occur if the model PLM-A35E is positioned in close proximity to any equipment emitting electromagnetic radiation. This product conforms with the following European Directives: 73/23/EEC, 93/68/EEC (Low Voltage Directive) 89/336/EEC, 92/31/EEC (EMC Directive) This equipment complies with EN55013 for use in following areas: residential, business and light-industrial. Congratulations on your purchase of a Sony Glasstron Personal Viewer. [. . . ] Each time you use this product, adjustment screens will appear, requiring the viewer to properly fit the product. To prevent eye damage, do not use this product if the vertical lines do not cross the horizontal line on the next screen. the Glasstron includes two small (left and right) LCDs. You are watching a combined picture created from these two screens. Although the screen position is properly aligned at the factory, it may become misaligned if the Glasstron is deformed or damaged. Check the screen position alignment every time you turn on the Glasstron. If you cannot have correct screen alignment, stop using the Glasstron immediately. Turn on the Glasstron using the POWER ON/OFF switch. Correct The combined picture you see with both eyes You may see a horizontal line on the left screen rather than the right screen and vertical lines on the right screen rather than the left screen. If the image you see matches one of the pictures below, you have correct screen alignment. If the image you see matches one of the pictures below, stop using the Glasstron immediately. Use of the Glasstron under such conditions may cause eye fatigue or eye damage. When no vertical lines cross the horizontal line. When the horizontal line appears as a diagonal line. When the centre vertical line does not cross the horizontal line. If you cannot see a proper arrangement of these lines even after resting your eyes for a few hours, the Glasstron may not be operating correctly. When you set the AVLS ON/OFF switch to ON, you cannot turn up the volume beyond the defined limit (see page 18). If the four corners of the screen are not clear, do the step 2 (page 16) to check the screen position alignment again. After you finish using the Glasstron Take off the Glasstron, and turn off the power. However, black points or bright points of light (red, blue, or green) may appear constantly on the LCD screen. To prevent eye fatigue or eye damage, after you use the Glasstron for three hours the following caution appears on the screen and the power turns off automatically. Preventing sound from escaping through the stereo headphones ­­ AVLS (Auto Volume Limiter System): Keeps down the maximum volume to protect your ear. [. . . ] Clean the product gently with a dry, soft cloth, or a soft cloth slightly moistened with a mild detergent solution. Do not use any type of solvent, such as alcohol or benzine. Reinsert the nose piece to its position. Gently push until it clicks into position. [. . . ]