User manual SONY PLM-S700

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. cAUTION You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] Turn on the Glasstron using the POWER switch, then press PUSH DISPLAY jog dial. If you have set the Glasstron to operate without a password, go to step 3. Turn the PUSH DISPLAY jog dial to enter the first number of your password, then press the jog dial. Enter the second and third numbers in the same way. If you enter a wrong password, the message shown on the right appears. If you have entered a wrong password more than five times, after about ten seconds, the Glasstron turns off automatically. 1 Warning message n Follow steps 3 through 7 in "Checking the display unit position" (pages 23 through 25). After carefully reading the warnings and checking the display unit position, press the jog dial. 2 Screen alignment n Follow steps 1 through 3 in "Checking the screen position alignment" (pages 25 through 27). Read the warning carefully, and press the jog dial. Make sure the left and right screens are aligned, and press the jog dial. When you display VGA pictures (640 × 480), the picture appears about 60% of the entire screen. If no picture appears, check the default setting of your PC to output the external RGB signal from the monitor connector. Some PCs do not output external display signal when they turn on, or switch to external display mode. Change the display mode of your PC, referring to the instruction manual supplied with your PC. When you display NTSC video picture, the picture appears about 60% of the entire screen. Adjust the sound volume by turning the VOL control. When you set AVLS in the menu to on, you cannot turn up the volume beyond the defined limit (see page 38). If the audio input level is too high, the sound may be distorted. Turn the volume down using the VOL control. After you finish using the Glasstron Take off the Glasstron, and turn off the power. However, black points or bright points of light (red, blue, or green) may appear constantly on the LCD screen. [. . . ] Charge the battery pack or replace with new batteries (page 41). Put the Glasstron on again to bring the forehead near to the POWER SAVING SENSOR (page 14). The battery pack is not charged Charge the battery pack fully or use a enough. Symptom The battery pack is not charged. [. . . ]