User manual SONY PLM-S700E

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Picture/sound distortion may occur if the model PLM-S700E is positioned in close proximity to any equipment emitting electromagnetic radiation. This product conforms with the following European Directives: 73/23/EEC, 93/68/EEC (Low Voltage Directive) 89/336/EEC, 92/31/EEC (EMC Directive) This equipment complies with EN55022 Class B for use in following areas: residential, business and light-industrial. The supplied interference cable must be used with the equipment in order to comply with the limits for a digital device pursuant to EN55022. [. . . ] If you have entered a wrong password more than five times, after about ten seconds, the Glasstron turns off automatically. 1 Warning message n Follow steps 3 through 7 in "Checking the display unit position" (pages 22 through 24). After carefully reading the warnings and checking the display unit position, press the jog dial. Screen alignment n Follow steps 1 through 3 in "Checking the screen position alignment" (pages 24 through 26). Read the warning carefully, and press the jog dial. Make sure the left and right screens are aligned, and press the jog dial. When you display VGA pictures (640 × 480), the picture appears about 60% of the entire screen. If no picture appears, check the default setting of your PC to output the external RGB signal from the monitor connector. Some PCs do not output external display signal when they turn on, or switch to external display mode. Change the display mode of your PC, referring to the instruction manual supplied with your PC. When you display PAL video picture, the picture appears about 84% of the entire screen. Adjust the sound volume by turning the VOL control. When you set AVLS in the menu to on, you cannot turn up the volume beyond the defined limit (see page 37). If the audio input level is too high, the sound may be distorted. Turn the volume down using the VOL control. After you finish using the Glasstron Take off the Glasstron, and turn off the power. However, black points or bright points of light (red, blue, or green) may appear constantly on the LCD screen. Press the jog dial while the picture is displayed. the display indication appears on the screen for five seconds. To turn off the indication sooner, press the jog dial again. * When using the AC power adapter, the " " mark appears on the screen. To prevent eye fatigue or eye damage, after you use the Glasstron for a fixed length of time, the following caution appears on the screen. [. . . ] ) The battery pack or batteries are dead. You put off the Glasstron while the POWER SAVE is set to ON. Put the Glasstron on again to bring the forehead near to the POWER SAVING SENSOR (page 13). Clean the display unit with a soft, dry cloth. [. . . ]