User manual SONY PLMA55

[. . . ] Use a commercially available AC plug adapter [a], if necessary, depending on the design of the wall outlet [b]. This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The supplied interface cable must be used with the equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] You can attach the supplied sunshades if you like. The sunshades prevent the LCD screen from reflecting light that may interfere with the picture. Attach the sunshades on the right and left sides of the display unit by inserting the tabs on the sunshades into the holes on the display unit in the order illustrated below. After you complete all of the connections and put on the Glasstron properly, turn on the Glasstron and follow the procedures below. 1 Checking the display unit position n This page 2 Checking the screen position alignment n Pages 20 through 22 3 Setting a password n Pages 22 and 23 If you do not want to use a password, you have to set the Glasstron to operate without using a password in "Setting the password. Every time you turn on the Glasstron, the adjustment screen appears to help you adjust the display unit properly. Turn on the Glasstron using the POWER switch. Turn the SEL/PUSH EXEC jog dial to select the language, English or French, then press the jog dial. Read the next WARNING and press the jog dial. Adjust the display unit so that you can see an asterisk (*) in each of the four corners as shown below. After you complete the display unit adjustment, press the jog dial. 1 Warning message n Follow steps 3 through 7 in "Checking the display unit position" (pages 18 through 20). After carefully reading the warnings and checking the display unit position, press the jog dial. 2 Screen alignment page n Follow steps 1 through 3 in "Checking the screen position alignment" (pages 20 through 22). Read the warning carefully, and press the jog dial. Make sure the left and right screens are aligned, and press the jog dial. When you set AVLS in the MENU to on , you cannot turn up the volume beyond the defined limit (see page 31). Lower Display unit After you finish using the Glasstron Take off the Glasstron, and turn off the power. Press the jog dial while the picture is displayed. the display indication appears on the screen for five minutes. To turn off the indication immediately, press the jog dial again. However, black points or bright points of light (red, blue, or green) may appear constantly on the LCD screen. [. . . ] Unauthorized substitutions may result in fire, electric shock, or other hazards. Upon completion of any service or repairs to the product, ask the service technician to perform routine safety checks (as specified by the manufacturer) to determine that the product is in safe operating condition, and to so certify. Unplug the product from the wall outlet before cleaning. Clean the product with a dry, soft cloth, or a soft cloth slightly moistened with a mild detergent solution. [. . . ]