User manual SONY PMC-205L

[. . . ] To prevent fire or shock hazard, do not expose the player to rain or moisture. You can use this player on AC power source only. When you use this player for the first time, or when you have not used it for a long time, leave it connected to AC power source for about one hour to charge the built-in backup battery for the clock, timer, preset radio stations, etc. The player will charge the battery automatically as long as it is connected to a power source. [. . . ] Use PRESET +/­ instead of the number buttons. Press and hold TIMER/CLOCK for about 2 seconds until the hour digit flash. You can wake up to music or a radio program at a preset time. Make sure you have set the clock ("Setting the clock" on page 19). Before you begin, make sure the t (clock) indication is not lit in the display. Prepare the music source you want to play. Press 0/­ or )/+ until the music source ("Cd" or "RAdiO") you want to play appears in the display and press DISPLAY/ENTER. The display window does not light while the waking up timer is operating even if the power is on. ⷠYou can have the player go on the next day at the same time. just press STANDBY until the t indication appears in the display. The preset settings remain until you reset them. Note The timer mode is cancelled: ­ when you press ( while music plays in the timer mode. ­ when you select "TAPE" using FUNCTION on the remote. Set the timer to the hour and the minutes you want the music to go on. Set the timer to the hour and the minutes you want the music to go off (Do as step 5). The t indication lights up and the power goes off. At the preset time, the power will go on and music will fade in. Then, the power will go off at the preset time, and the player will enter the standby mode. To check/change when the playback will start Press TIMER/CLOCK, then DISPLAY/ENTER. Each time you press DISPLAY/ENTER, a stored setting lights up. Change the setting if you need to when the setting lights up. when you finish checking , press TIMER/CLOCK. [. . . ] Make sure the safety tab of the cassette is in place. ⷠClean the heads, pinch rollers and capstans (See page 33). Check to see if the AC power had been cut off. Make sure the tape has not wound to the end. [. . . ]