User manual SONY PMC-20L

[. . . ] To prevent fire or shock hazard, do not expose the player to rain or moisture. Note The name of the switch to turn on/off this player is indicated as below: PMC-20L: "OPERATE": All countries PMC-107L: "OPERATE": European countries (excluding central and eastern Europe) "POWER": Other countries You can use this player on AC power source only. When you use this player for the first time, or when you have not used it for a long time, leave it connected to AC power source for about one hour to charge the built-in backup battery for the clock, timer, preset radio stations, etc. The player will charge the battery automatically as long as it is connected to a power source. [. . . ] Hold down BAND for about 2 seconds until "AUTO" appears in the display. The stations are stored in memory from the lower frequencies to the higher ones. 4 Press PRESET+ or ­ until the preset number (1 to 10) you want for the station flashes in the music calendar. If a station cannot be preset automatically You need to preset a station with a weak signal manually. Also, when you want to replace a preset station with a new one, proceed as follows: Use the remote. 1 Press BAND until the band you want appears in the display. 2 Set the frequency to the station you want. 3 Hold down the number buttons that you want to preset the new station for 2 seconds. Once you've preset the stations, use the number buttons on the remote or the PRESET +/­ to tune in your favorite stations. Press CLOCK for 2 seconds until the hour digit flashes. Set the minutes by pressing TUNING/TIME SET + or ­ until the correct minute is displayed. You can wake up to music or a radio program at a preset time. Make sure you have set the clock ("Setting the clock" on page 19). Before you begin, make sure the t (clock) indication is not lit in the display. Prepare the music source you want to play. To play the radio a CD Do this Tune in a station. Select the music source ("Cd" or "RAdIO") by pressing TUNING/TIME SET + or ­, then DISPLAY· eNTER MEMORY. Set the timer to the hour you want the music to start by pressing TUNING/TIME SET + or ­, then DISPLAY· Set the timer to the hour and the minutes you want the music to go off. Tip You can have the player go on the next day at the same time. just press STANDBY until the t indication appears in the display. The preset settings remain until you reset them. Note The timer mode is canceled: ­ when you press ( button of the tape player while music plays in the timer mode. [. . . ] Should this occur, the player will not operate properly. In this case, remove the CD and wait about an hour for the moisture to evaporate. Make sure the safety tab on the cassette is in place. Make sure the safety tab of the cassette is in place. [. . . ]