User manual SONY PMC-303L

[. . . ] To prevent fire or shock hazard, do not expose the player to rain or moisture. Notice for customers in the United Kingdom A moulded plug complying with BS 1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, same rating fuse approved by ASTA or BSI to BS 1362, (i. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] Then the power will go off after 60 minutes. Change the setting if you need to when the setting lights up. when you finish checking , press ALARM. To use the player before a timer playback starts If you turn on the player, you can use it as usual ( in case of the radio, if you listen to the station which is different from the one you tuned in in step 1 on page 22, you will hear that station at the preset time. ) Turn off the player before the preset time. Setting the music source, the time you want the source to go on and off, and the volume of the source (TIMER) Before you begin, make sure the t (clock) indication is not lit in the display. Prepare the music source you want to play. Press SELECT +/­ until the music source you want to play appears in the display (you cannot select "BUZZER". Tip If you made a mistake, press CANCEL. Each time you press the button, the last setting is cleared. Set the timer to the hour and the minutes you want the music to go on. Set the timer to the hour and the minutes you want the music to go off (Do as step 4. The t indication lights up and the power goes off. At the preset time, the power will go on and music will fade in. Then music will fade out and the power will go off at the preset time. The preset settings remain until you reset them. ⷠThe display window dims while the waking up timer is on. To check/change when the playback will start Press TIMER, then ENTER. Each time you press ENTER, a stored setting lights up. Change the setting if you need to when the setting lights up. when you finish checking , press TIMER. To use the player before a timer playback starts If you turn on the player, you can use it as usual ( in case of the radio, if you listen to the station which is different from the one you tuned in in step 1 on page 24, you will hear that station at the preset time. [. . . ] Check to see if the AC power had been cut off. Make sure the tape has not wound to the end. The tape player cannot be paused during playback. Replace all the batteries in the remote with new ones if they are weak. [. . . ]