User manual SONY PMC-107

[. . . ] To prevent fire or shock hazard, do not expose the player to rain or moisture. This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. And used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Press BAND until the band you want appears in the display. Hold down BAND for about 2 seconds until "AUTO" appears in the display. The stations are stored in memory from the lower frequencies to the higher ones. 4 Press PRESET+ or ­ until the preset number (1 to 10) you want for the station flashes in the music calendar. If a station cannot be preset automatically You need to preset a station with a weak signal manually. Also, when you want to replace a preset station with a new one, proceed as follows: Use the remote. 1 Press BAND until the band you want appears in the display. 2 Set the frequency to the station you want. 3 Hold down the number buttons that you want to preset the new station for 2 seconds. Once you've preset the stations, use the number buttons on the remote or the PRESET +/­ to tune in your favorite stations. Press CLOCK for 2 seconds until the hour digit flashes. Set the minutes by pressing TUNING/TIME SET + or ­ until the correct minute is displayed. You can wake up to music or a radio program at a preset time. Make sure you have set the clock ("Setting the clock" on page 19). Before you begin, make sure the t (clock) indication is not lit in the display. Prepare the music source you want to play. To play the radio a CD Do this Tune in a station. Select the music source ("Cd" or "RAdIO") by pressing TUNING/TIME SET + or ­, then DISPLAY· eNTER MEMORY. Set the timer to the hour you want the music to start by pressing TUNING/TIME SET + or ­, then DISPLAY· Set the timer to the hour and the minutes you want the music to go off. Tip You can have the player go on the next day at the same time. just press STANDBY until the t indication appears in the display. The preset settings remain until you reset them. [. . . ] Make sure the safety tab on the cassette is in place. Make sure the safety tab of the cassette is in place. ⷠClean the heads, pinch roller and capstan (see page 30). Check to see if the AC power had been cut off. [. . . ]