User manual SONY PMC-DR45

[. . . ] 3-044-713-71 (2) Personal Component System Operating Instructions PMC-DR45 © 2000 Sony Corporation Warning To prevent fire or shock hazard, do not expose the player to rain or moisture. This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. [. . . ] · When you select both sides recording, the recording will stop after the both sides recording finishes so that accidental recording will not be made. 8 Press STANDBY. The power goes off and the player enters the standby mode. The indication and the recording side of the tape (upper side N or reverse side n) appear in the display. If the n indication appears, press STANDBY to change the recording side to N. At the preset time, the power will go on and the recording will start. Then the power will go off at the preset time, and the player will enter the standby mode again. continued The Timer 29 Timer-recording radio programs (continued) To check/change the recording timer settings Press TIMER, then ENTER MEMORY. Each time you press ENTER MEMORY, a stored setting is displayed in the set order. To change the setting, display the setting you want to change and re-enter it. To use the player before a timer-recording starts If you turn on the player, you can use it as usual. Before the preset time, tune in the station you want to record and turn off the power. To stop timer-recording Turn off the power. Note During timer-recording, the SNOOZE function does not work. 30 The Timer Falling asleep to music You can set the player to turn off automatically after 10, 20, 30, 60, 90 and 120 minutes, allowing you to fall asleep while listening to music. SLEEP The Timer Tips · The display window dims while the sleeping timer is on. · You can combine the waking up timer with the sleeping timer. Set the waking up timer first (page 25), turn on the power, and then set the sleeping timer. · You can prepare the different music for the waking up timer and the sleeping timer. However, you cannot store different radio stations. · You can set different volume for the waking up timer and the sleeping timer. For instance, you can sleep at lower volume and wake up at higher volume. 1 2 3 Play the music source you want. Press SLEEP to display "SLEEP. " Press SLEEP to select the minutes until the player goes off automatically. Each time you press the button, the indication changes as follows: "60" t "90" t "120" t no indication t "10" t "20" t "30". If 4 seconds have passed after you pressed SLEEP, the minutes in the display are stored in memory. When the preset time has passed, music stops and the player goes off automatically. To cancel the sleep function Press SLEEP to make "SLEEP" disappear from the display. To change the preset time Do the steps 2 and 3 again. The Timer 31 Setting Up Hooking up the system According to the illustrations, connect the cords firmly. [. . . ] · Make sure the tape is inserted properly. · Make sure the safety tab of the cassette is in place. The audio is weak/The audio quality is poor. · Clean the heads, pinch rollers and capstans (see page 46). [. . . ]