User manual SONY PMC-DR50

[. . . ] 3-867-748-71 (1) Personal Component System Operating Instructions PMC-DR50 ©2000 Sony Corporation Warning To prevent fire or shock hazard, do not expose the player to rain or moisture. This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] If the n indication appears, press STANDBY to change the recording side to N. At the preset time, the power will go on and the recording will start. Then the power will go off at the preset time, and the player will enter the standby mode again. 28 The Timer To check/change the recording timer settings Press TIMER, then ENTER MEM. Each time you press ENTER MEM, a stored setting is displayed in the set order. To change the setting, display the setting you want to change and re-enter it. To use the player before a timer-recording starts If you turn on the player, you can use it as usual. Before the preset time, tune in the station you want to record and turn off the power. The Timer Note During timer-recording, the SNOOZE function does not work. To stop timer-recording Turn off the power. The Timer 29 Falling asleep to music You can set the player to turn off automatically after 10, 20, 30, 60, 90 and 120 minutes, allowing you to fall asleep while listening to music. SLEEP Tips · The display window dims while the sleeping timer is on. · You can combine the waking up timer with the sleeping timer. Set the waking up timer first (page 24), turn on the power, and then set the sleeping timer. · You can prepare the different music for the waking up timer and the sleeping timer. However, you cannot store different radio stations. · You can set different volume for the waking up timer and the sleeping timer. For instance, you can sleep at lower volume and wake up at higher volume. 1 2 3 Play the music source you want. Press SLEEP to display "SLEEP. " Press SLEEP to select the minutes until the player goes off automatically. Each time you press the button, the indication changes as follows: "60" t "90" t "120" t no indication t "10" t "20" t "30". If 4 seconds have passed after you pressed SLEEP, the minutes in the display are stored in memory. When the preset time has passed, music stops and the player goes off automatically. To cancel the sleep function Press SLEEP to make "SLEEP" disappear from the display. To change the preset time Do the steps 2 and 3 again. 30 The Timer Setting Up Hooking up the system According to the illustrations, connect the cords firmly. Connect the AC power cord last. 2 AM loop antenna 2 FM lead antenna 1 Power cord Right speaker Setting Up Left speaker 3 AC power cord Notes · Be sure to turn off the power of the player before connecting/ disconnecting the AC power cord. · Connect the supplied speakers to this player. If you connect any other speakers or equipment, a malfunction may occur. 1 Audio connecting cord to a wall outlet 1 Speaker cord 1 Hooking up the speakers 1 Connect the power cord of the POWER OUT TO MAIN UNIT on the right speaker to the POWER IN FROM SP-R jack of the player. continued Setting Up 31 Hooking up the system (continued) 2 Connect the audio connecting cord (supplied) to the SIGNAL OUT jacks of the player and the SIGNAL IN jacks of the right speaker. Connect the white plugs to the L (left) jacks and the red plugs to the R (right) jacks. 3 Connect the speaker cord of the left speaker to the SPEAKER OUT L terminals of the right speaker. [. . . ] · Demagnetize the heads using a demagnetizer (see page 45). The tape player cannot be paused during playback. · The tape player can be paused during recording only. Tape Player continued Additional Information 43 Troubleshooting (continued) Symptom The timer does not operate. Remedy · Make sure the time on the clock is correct. · Check to see if the AC power had been cut off. [. . . ]