User manual SONY PRS-700BC

[. . . ] The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. Do not leave the unit in a location near a heat source, such as a radiator or airduct, or in a place subject to direct sunlight, excessive dust, mechanical vibration, or shock. Allow adequate air circulation to prevent internal heat build-up. Do not place the unit on a surface (a rug, blanket, etc. [. . . ] Each press changes the band as follows: ICF-C273 For the sound alarm, the sound you specified as the wake-up sound is played. When using FM1 or FM2 preset mode, you may listen to the radio on either mode. Time display UK, Australia, North and South America Other countries/regions 12 hour 24 hour Use TUNING + or ­ to tune into the desired station. " Two short beeps sound when the minimum frequency of each band is received during tuning. Model for other countries/regions Band FM LW ICF-C273 PRS-700BC Channel step 87. The speaker is deactivated when an earphone is connected (ICF-C273 for European model only) To check the station being received, press TUNING + or ­ or ON/BAND lightly. The display shows the band and frequency for a few seconds and then changes back to the current time. If the same alarm time is set for both Alarm A and B, Alarm A takes priority. 6 oz) Design and specifications are subject to change without notice. The radio or buzzer turns off but will automatically come on again after about 10 minutes. Every time you press SNOOZE/DATE/SLEEP OFF, the snooze time changes as follows: Do not operate the unit over a steel desk or metal surface, as this may lead to interference of reception. The display shows the frequency for a few seconds and then changes back to the current time. To preset another station, repeat these steps. To change the preset station, tune into the desired station and hold down the PRESET TUNING 1 to 5 button. Press Jog lever (up) or (down) until the correct year appears in the display. Repeat steps 3 and 4 to set the month, day, hour, and minute. After setting the minute, press ENTER/ BRIGHTNESS to start the counting of the seconds, and you will hear two short beeps. 12-hour system: "AM 12:00" = midnight 24-hour system: "0:00" = midnight In step 5, when you press ENTER/BRIGHTNESS after the minute setting to activate the clock, the seconds start counting from zero. When the alarm setting mode is entered, the clock cannot be set. After a few seconds, the display will return to the current time but the preset button number will remain. You can fall asleep to the radio using the built-in sleep timer that turns off the radio automatically after a preset duration. You can set the sleep timer to durations of 90, 60, 30, or 15 minutes. [. . . ] To turn off the radio before the preset time, press SNOOZE/DATE/SLEEP OFF. Green backlight LCD with adjustable brightness. Date button to display the year, month and day. Easy preset digital tuning with 15 memory presets for ICF-C273, 20 memory presets for PRS-700BC. [. . . ]