User manual SONY PS-FL7II

[. . . ] Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. To reduce the risk of fire or electric shock, do not place objects filled with liquids, such as vases, on the apparatus. WARNING This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] 11 Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 Parts and Controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 GB Getting Started 2 Carefully place the platter on the spindle. Unpacking Check that you received the following items with your turntable: Platter (with drive belt) (1) Rubber mat (1) 45 r/min adaptor (1) USB cable (1) Supplied CD-ROM, "Sound Forge Audio Studio LE" included (1) Operating Instructions (this manual) The installation guide for "Sound Forge Audio Studio LE" Getting Started 3 Using the ribbon, loop the drive belt around the motor pully. After looping the belt, do not forget to remove the ribbon. Assembling the Turntable 4 Place the rubber mat on the platter. 1 Move the metallic parts inside the larger gear in the direction of the arrow. Note When the AC power cord is plugged after assembling or moving the turntable, the turntable sometimes rotates and the torn arm descends to the platter even if START is not pressed. If this occurs, press STOP to return the tone arm to the arm stand. Continued GB To remove the dust cover With the dust cover fully opened, grasp both sides of the cover, then remove it carefully. Hooking Up the Turntable The phono cables come attached to the rear of the cabinet. 1 Set the PHONO/LINE switch (on Hinge pocket Hinge the rear of the turntable) according to the jacks of your stereo system (amplifier). Tip You can use the turntable leaving the dust cover removed. In that case, store the cover correctly. To install the dust cover Insert the hinge pockets on the dust cover into the hinges on the rear of the cabinet. · When your stereo system (amplifier) has PHONO input jacks (connect to PHONO input jacks) set to PHONO. · When your stereo system (amplifier) does not have PHONO input jacks (connect to AUX, VIDEO input jacks, etc. ) set to LINE. The Equalizer function is on. 2 Connect the cable with the white plug to the white (L) jack and connect the cable with the red plug to the red (R) jack. Make sure to insert the plugs firmly into the jacks. If the plugs are not inserted firmly, noise may occur. 3 Connect the AC power cord. Connect the AC power cord to an AC wall outlet after completing all of the connections by performing steps 1 and 2. GB to a wall outlet Operations 7 Adjust the volume on your amplifier. When playback is finished The tone arm returns to the arm stand automatically, then the platter stops rotating. Playing a Vinyl Record To stop playing Press the STOP button. The tone arm returns to the arm stand. The platter stops rotating. 45 r/min adaptor STOP To pause playing UP/DOWN Operations Press the UP/DOWN button to raise the stylus off the vinyl record. 1 Place a vinyl record on the platter. To play a different part of the vinyl record 1 After performing step 4, press the UP/ DOWN button, then lift the tone arm. To clean the stylus, brush it from back to front using a good quality stylus cleaning brush. Do not clean the stylus with your finger tip. When using a fluid stylus cleaner, make sure not to moisten the stylus too much. Precautions On safety Before operating the unit, check that the operating voltage of your unit is identical with that of your local power supply. Should any solid object or liquid fall into the cabinet, unplug the unit and have it checked by qualified personnel before operating it any further. Unplug the unit from the wall outlet if it is not to be used for an extended period of time. To disconnect the cord, pull it out by the plug. On placement Place the unit on a level surface. Avoid placing the unit near electrical appliances (such as a television, hair dryer, or fluorescent lamp) which may cause hum or noise. Place the unit where it will not be subject to any vibration, such as from speakers, slamming of doors, etc. Keep the unit away from direct sunlight, extremes of temperature, and excessive dust and moisture. On repacking Keep the carton and packing materials. [. . . ] Dust or dirt has collected on the vinyl record. Clean the record using a good quality record cleaner. The turntable is placed too close to speakers. Move speakers away from the turntable. * This phenomenon, called "acoustic feedback", occurs when vibrations from the speakers are transmitted through the air or via solid objects (such as shelves, a cabinet, or the floor) to the turntable where they are picked up by the stylus, amplified and reproduced through the speakers. USBconnection/recording The turntable is not detected on your computer. [. . . ]