User manual SONY PS-J20

[. . . ] A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a fuse of the same rating as the supplied one and approved by ASTA or BSI to BS1362, (i. [. . . ] â· Keep the unit away from direct sunlight, extremes of temperature, and excessive dust and moisture. Remove the lid, and set the voltage selector to the local power line voltage using a screwdriver. Connect the cable with the red plug to the right PHONO IN R input jack on the amplifier and connect the cable with the white plug to the left PHONO IN L input jack. On the bottom panel according to the amplifier connection as follows: For connection to Connect the mains lead to an AC wall outlet after completing all of the previous connections. Install this system so that the power cord can be unplugged from the wall socket immediately in the event of trouble. Set the cueing lever backward to raise stylus off the record during playback. To listen to a different part of the record Set the cueing lever backward to raise stylus during playback. Move the tone arm to the position you desire. To play a 17-cm record When you have finished using the adaptor, put it back in the adaptor tray. Place only one record on the platter at a time. If two or more records are stacked on the platter, the stylus will not make proper contact with the grooves and the quality of reproduction will be impaired. Remove the protective cover from the cartridge, and release the stopper from the tone arm. [. . . ] Clean the record with a commercially available record cleaning kit, or replace the record. 5cm, molded aluminum alloy 33 1/3 and 45 r/min, 2 speed Less than 0. [. . . ]