User manual SONY PS-LX300H

[. . . ] The model number and serial numbers are located at the rear. record these numbers in the spaces provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. If you have any question or problem concerning your unit that is not covered in this manual, please consult your nearest Sony dealer. [. . . ] To listen to a different part of the record Lift the cueing lever to raise stylus during playback. Move the tone arm to the position you desire. To play a 17-cm record Place only one record on the platter at a time. If two or more records are stacked on the platter, the stylus will not make proper contact with the grooves and the quality of reproduction will be impaired. When you have finished using the adaptor, put it back in the adaptor tray. You can make fine adjustments to the platter speed by using the PITCH CONTROL. Press POWER to turn on the record turntable. If you select 33 r/min when the turntable is connected to a 50 Hz power source, the innermost row of the strobo dots should appear to stand still. If the strobo dots do not stand still when the PITCH CONTROL is set to the center position Use the platter speed controls (33 or 45) on the bottom of the turntable to adjust the platter speed so that the respective strobo dots appear to stand still. The tone arm descends slowly to the record and playback begins. In order to prevent premature stylus and record wear, the stylus and record should be cleaned before playback. To clean the stylus, brush it from back to front using a good quality stylus cleaning brush. Do not clean the stylus with your finger tip. When using a fluid stylus cleaner, make sure not to moisten the stylus too much. Turn the locking collar and remove the cartridge from the tone arm. Grasp the stylus holder and pull it away from the body of the cartridge. Insert the new stylus by pushing it into the cartridge receptacle. If you find it necessary to replace the cartridge detach the headshell from the tone arm and follow the directions below. To clean your records, wipe thoroughly using a good quality record cleaner. 1 2 Remove the screws holding the cartridge to the headshell. [. . . ] B Check that the cartridge lead wires inside the headshell are firmly attached. Die-cast aluminum alloy 33 1/3 and 45 r/min, 2 speed Less than 0. 1% (WRMS) More than 55 dB (DIN-B) with supplied cartridge Move speakers away from the turntable. ) b The PITCH CONTROL is not set to the center position. [. . . ]