User manual SONY PS-LX350H

[. . . ] · Keep the unit away from direct sunlight, extremes of temperature, and excessive dust and moisture. This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. Owner's Record The model number and serial numbers are located at the rear. Record these numbers in the spaces provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. [. . . ] Adjust the volume on your amplifier. 8 1 2 4 6, 7 5 3 6 3 5 To stop playing 1 2 1 Place a record on the platter. 3 Shift the cueing lever forward to lift up the tone arm, return the tone arm to the arm stand. Attach the protective cover onto the cartridge to prevent damage to the stylus. Shift the cueing lever forward and fix the tone arm with the arm stopper. Turn POWER to "·" to turn the turntable off. To pause playback Shift the cueing lever forward to raise the stylus off the record during playback. To listen to a different part of the record 1 2 3 Note Place only one record on the platter at a time. If two or more records are stacked on the platter, the stylus will not make proper contact with the grooves and the quality of reproduction will be impaired. Shift the cueing lever forward to raise the stylus during playback. Move the tone arm to the position you desire. Shift the cueing lever backward. To play a 17-cm record Place the supplied 45 r/min adaptor on the spindle. When you have finished using the adaptor, put it back in the adaptor tray. If the strobo dots do not stand still when the PITCH CONTROL is set to the center position Slide toward + or ­ to adjust the platter speed so that the respective strobo dots appear to stand still. 2 Turn POWER to "1" to turn on the record turntable. Set the PITCH CONTROL to the center position and press 33 or 45 to select the platter speed. The indicator for the selected speed lights up. If you select 45 r/min when the turntable is connected to a 50 Hz power source, the innermost row of the strobo dots should appear to stand still. 50 Hz 60 Hz 50 Hz 60 Hz 3 Note When the unit is turned on, the speed is automatically set to 33 r/min. 4 If you have an extra headshell, retain it in the headshell holder. 45 33 5 6 Remove the protective cover from the cartridge and disengage the arm stopper. Move the tone arm to the desired position over the record. 7 Additional Information To replace the stylus Maintenance Stylus and Record Care In order to prevent premature stylus and record wear, the stylus and record should be cleaned before playback. To clean the stylus, brush it from back to front using a good quality stylus cleaning brush. Do not clean the stylus with your finger tip. When using a fluid stylus cleaner, make sure not to moisten the stylus too much. 1 2 3 4 Turn off the turntable and amplifier. [. . . ] Clean the record with a commercially available record cleaning kit, or replace the record. b Make sure the power cord is inserted all the way into an AC wall outlet. b The drive belt is not completely hooked onto the motor pulley. Make sure the belt is hooked completely around the motor pulley (see page 4). The drive belt is broken. b Replace the drive belt. [. . . ]