User manual SONY PVM-2950Q

[. . . ] For Macintosh Load the supplied CD-ROM into the CD-ROM drive of your computer. Note If you are using Mac OS X, activate the Adobe Acrobat Reader first, then double-click on "Manual. The equipment should be installed near an easily accessible outlet. [. . . ] Subjecting the monitor to extreme temperatures, such as in an automobile parked in direct sunlight or near a heating vent, could cause deformations of the casing or malfunctions. Near any equipment that generates a strong magnetic field, such as a TV or various other household appliances. In places subject to inordinate amounts of dust, dirt, or sand, for example near an open window or an outdoor exit. If setting up temporarily in an outdoor environment, be sure to take adequate precautions against airborne dust and dirt. Otherwise irreparable malfunctions could occur. If you cannot open the Operating Instruction files Adobe Acrobat Reader may not be installed on your computer. You can download it for free from the Adobe Web site. Make sure your carton contains everything listed below. However, black points or bright points of light (red, blue, or green) may appear constantly on the LCD screen, and irregular colored stripes or brightness may appear on the LCD screen. X Problems caused by a computer or other equipment connected, and not caused by the monitor · check that the video frequency range is within that specified for the monitor. If you replaced an old monitor with this monitor, reconnect the old monitor and adjust the computer's graphics board within the following ranges: Horizontal: 28 ­ 61 kHz (SDM-HS53), 28 ­ 80 kHz (PVM-2950Q/HS93) Vertical: 48 ­ 75 Hz · If you replaced an old monitor with this monitor, reconnect the old monitor and do the following. Select "SONY" from the "Manufacturers" list and select "SDM-HS53, " "PVM-2950Q" or "SDM-HS93" from the "Models" list in the Windows device selection screen. If the model name of this monitor does not appear in the "Models" list, try "Plug & Play. If NO INPUT SIGNAL appears on the screen, or the 1 (power) indicator is either orange or alternating between green and orange, If you are using Windows and replaced an old monitor with this monitor, This monitor is equipped with a self-diagnosis function. If there is a problem with your monitor or computer(s), the screen will go blank and the 1 (power) indicator will either light up in green or flash orange. If the function tells you the monitor may have a potential failure, consult your authorized Sony dealer. If the picture disappears from the screen and the 1 (power) indicator is green If all four color bars appear (white, red, green, blue), the monitor is working properly. Reconnect the video input cables and check the condition of your computer(s). [. . . ] Reconnect the video input cables and check the condition of your computer(s). If the color bars do not appear, there is a potential monitor failure. If the picture disappears from the screen and the 1 (power) indicator is flashing orange Press the 1 (power) switch twice to turn the monitor off and then on. [. . . ]