User manual SONY PVM-1944Q

[. . . ] Dangerously high voltages are present inside the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] 0 instruction manual for further details on adjusting the resolution, refresh rate, and number of colors. To close the menu Press the center of the control button once to return to the main MENU, and twice to return to normal viewing. If no buttons are pressed, the menu closes automatically after about 30 seconds. You can make numerous adjustments to your monitor using the on-screen menu. Press the center of the control button to display the main MENU on your screen. See page 9 for more information on using the control button. Use the control button to select one of the following menus. If the signal matches one of this monitor's factory preset modes, the resolution is also displayed. You can use this to match the monitor's colors to a printed picture's colors. Press the center of the control button to display the main MENU on your screen. Brightness and contrast adjustments are made using a separate BRIGHTNESS/CONTRAST menu. Select LANDING LANDING To reduce any color irregularities in the screen's top left corner to a minimum. Reduce any color irregularities in the screen's top right corner to a minimum. Reduce any color irregularities in the screen's bottom left corner to a minimum. Reduce any color irregularities in the screen's bottom right corner to a minimum. Moire is a type of natural interference which produces soft, wavy lines on your screen. It may appear due to interference between the pattern of the picture on the screen and the phosphor pitch pattern of the monitor. Note The picture may become fuzzy when CANCEL MOIRE is set to ON. The COLOR settings allow you to adjust the picture's color temperature by changing the color level of the white color field. These settings are stored in memory for all input signals. You can make additional adjustments to the color in greater detail by selecting the EXPERT mode. This adjusts the dark areas of an image. [. . . ] If you place equipment that generates a magnetic field, such as a speaker, near the monitor, or if you change the direction the monitor faces, color may lose uniformity. This is the sound of the auto-degauss cycle. When the power is turned on, the monitor is automatically degaussed for two seconds. White does not look white Letters and lines show red or blue shadows at the edges Monitor buttons do not operate ( appears on the screen) A hum is heard right after the power is turned on * If a second degauss cycle is needed, allow a minimum interval of 20 minutes for the best result. [. . . ]