User manual SONY R701PC

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. To prevent fire, do not cover the ventilation of the apparatus with news papers, table cloths, curtains, etc. and don't place lighted candles on the apparatus. [. . . ] " This keeps the beep sound out of the recorded signal or the output from the externally connected equipment. Press MENU, press <SELECT, repeatedly until "BEEP" flashes in the display, and then press ENTER. Press <SELECT, repeatedly until "BEEP OFF" flashes in the display, and then press ENTER. To turn on the beep sound Select "BEEP ON" in step 2. If you do not want the effect of the Mega Bass function on your recording or the output from the externally connected equipment, set "BASS" to "BASS OFF" (page 34). ⷠWhen recording to an externally connected equipment, press VOL + repeatedly to raise the volume level to maximum, which is optimum for recording to an externally connected equipment. If, however, this level produces distortion in the recording, press VOL ­ several times to lower the level (to that shown in the illustration below). You can edit your recordings by adding/erasing track marks or labeling tracks and MDs. Do not move or jog the recorder while "TOC Edit"* is flashing in the display. Before editing tracks, close the tab on the side of the MD (page 54). ⷠIf you perform an editing operation while playing, be sure not to turn the power off until "TOC Edit" disappears in the display. ⷠThe lid does not open until "TOC Edit" disappears in the display after editing. When you operate the recorder with the supplied remote control, use the buttons and controls shown in parentheses. Note that once a recording has been erased, you cannot retrieve it. While playing the track you want to erase, press MENU (EDIT for 2 seconds or more). ) repeatedly until "EDIT" flashes in the display, and then press ENTER (ENTER). " : Name" flashes in the display, and the recorder plays the selected track repeatedly. press <SELECT , (flip the lever towards > or . ) repeatedly until " : Erase" flashes in the display, and then press ENTER (ENTER). The track is erased and the next track starts to play. All the tracks after the one erased are automatically renumbered. To erase a part of a track Add track marks at the beginning and the end of the part you want to erase, then erase the part (page 42). [. . . ] ⷠYou tried to erase a track mark to combine tracks the recorder cannot combine (a track recorded in different recording mode, or a track recorded through a digital connection and an analog connection, for example). ⷠYou tried to press X, T MARK, or REC MODE during synchrorecording. tEMP OVER · Heat has built up in the recorder. There is no more space for new data when you are editing the MD. [. . . ]