User manual SONY RCD-W1

[. . . ] 4-233-692-12(1) Compact Disc Recorder Operating Instructions Owner's Record The model and serial numbers are located on the rear panel. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. Model No. Serial No. RCD-W1 ©2001 Sony Corporation WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] See "Finalizing CD-R and CD-RW discs" on page 20. "TOC" starts to flash. The recorder starts to read the TOC (Table of Contents) data and shows the type of the disc in the deck on the front panel display. When you place a CD-RW in the deck, the recorder optimizes itself for the best possible recording and "OPC" appears on the display shortly. Recording on CDR 3 Press A of DECK A and place a CD on the disc tray. Press A of DECK A again to close the disc tray. 4 Press CD SYNCHRO NORMAL. "CD SYNCHRO" appears and "REC" flashes in the front panel display. DECK B stands by for recording, and DECK A stands by for playing. 5 Press H on the front panel or on the remote to start recording. Recording starts. DECK A and DECK B will automatically stop after recording. To stop recording CD SYNCHRO NORMAL CD SYNCHRO NORMAL Press x. Notes 1 Press POWER. 2 Press A of DECK B and place a recordable CD-R or CD-RW on the disc tray. Press A of DECK B again to close the disc tray. · When copying a disc digitally recorded under control of the Serial Copy Management System (SCMS), the recorder automatically select the analog recording. For detailed explanation on SCMS, refer to the "Notes" on page 18. · When copying a commercial music CD contains copy-prohibit signals, the recorder automatically select the analog recording. · You cannot monitor the sound being recorded during recording. When you want to monitor the sound when you are recording, change the source selector of the amplifier to DECK A, or use a headphone. With the label side up 15 Recording a CD to CD-R or CD-RW disc at High Speed (High Speed Synchro-Recording) You can easily make digital recordings from a CD to a CD-R, or CD-RW, faster than normal Synchro-Recording, making track numbers in the same sequence as the original CD. Before recording, see "Notes" on page 17. After recording, you must finalize the disc. Until the disc is properly finalized, it cannot be played on any other machine. See "Finalizing CD-R and CD-RW discs" on page 20. "TOC" starts to flash. The recorder starts to read the TOC (Table of Contents) data and shows the type of the disc in the deck on the front panel display. When you place a CD-RW in the deck, the recorder optimizes itself for the best possible recording and "OPC" appears on the display shortly. 3 Press A of DECK A and place a CD on the disc tray. Press A of DECK A again to close the disc tray. 4 Press CD SYNCHRO HIGH. "CD SYNCHRO" appears and "REC" flashes in the front panel display. DECK B stands by for recording, and DECK A stands by for playing. 5 Press H on the front panel or on the remote to start recording. CD SYNCHRO HIGH High-Speed recording starts. [. . . ] Moisture condensation has formed inside the recorder. Take the disc out and leave the recorder turned on for about an hour until the moisture evaporates. · Press POWER to turn the recorder on. · Make the connections properly. · Operate the amplifier properly. [. . . ]