User manual SONY RCD-W222ES

[. . . ] 4-240-491-11(1) Compact Disc Recorder Operating Instructions Owner's Record The model and serial numbers are located on the rear panel. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. Model No. Serial No. RCD-W222ES ©2002 Sony Corporation WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. The following caution label is located inside the apparatus. Don't throw away the battery with general house waste, dispose of it correctly as chemical waste. This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] See "Finalizing a CD-R or CD-RW" on page 24. · A CD text contained in the disc is not automatically recorded on the disc. To label tracks/discs, see "Labeling Tracks/Discs" (page 26). Tip · You cannot pause recording in Synchro-Recording. · If Repeat Play has been set, it is automatically canceled. · If you start the recording when Shuffle play is set, Shuffle play is automatically canceled. · Silent Pause and SBM functions do not work during Synchro-Recording. · The recording level is set to 0. 0 dB regardless of the Setup Menu setting. · When copying a disc digitally recorded under control of the Serial Copy Management System (SCMS), the unit automatically select the analog recording. High speed recording changes to normal speed recording. For detailed explanation on SCMS, refer to the "Notes" on page 20. · When copying a commercial music CD contains copy protection code, the unit automatically select the analog recording. High speed recording changes to normal speed recording. · You cannot stop recording during finalizing in Make-Disc Synchro-Recording. Normal speed SynchroRecording The disc is recorded at the same speed as the playing CD. You can hear the sound during recording. When using the remote, set SELECT to CDR. POWER DISC 1-5 A OPEN/CLOSE You can perform Synchro-Recording in the programmed order (page 15). Make-Disc Synchro-Recording (MAKE DISC) Records a CD in the original order of its track number regardless of the selected play mode, and finalizes the disc. Be sure to use the disc that has not been recorded. ("Blank Disc" appears in the display when you put the disc in DECK B. ) · A CD text (if contained in the disc) is automatically recorded. (Note that "Text Save" in Setup Menu is set to "On. " ) You can enter the disc name or track name (up to 70 characters each, and 40 tracks per disc). Tip CD SYNCHRO NORMAL Nx SELECT When you do not want to record the CD text automatically, set "Text Save" in Setup Menu to "Off. " For details, see "Using the Setup Menu" (page 28). Depending on the CDs, the CD text is automatically recorded even if "Text Save" in Setup Menu is set to "Off. " H CD SYNCHRO NORMAL x 18 1 Press POWER. 2 Press OPEN/CLOSE of DECK B and place a recordable CD-R or CD-RW on the disc tray. Press OPEN/CLOSE of DECK B again to close the disc tray. High-Speed Synchro-Recording You can easily make digital recordings from a CD to a CD-R or CD-RW, faster than normal speed Synchro-Recording. You cannot monitor the recorded signal while recording. [. . . ] · Operate the amplifier properly. · When using the headphones, turn PHONE LEVEL to turn up the output level. The remote does not operate the unit. Additional Information Insert a disc. Moisture condensation has formed inside the unit. Take the disc out and leave the unit turned on for about an hour until the moisture evaporates (page 4). [. . . ]