User manual SONY RDP-M5IPSIL

[. . . ] the lead from the jack inside the battery compartment. Personal Audio Docking System Do not expose the batteries (battery pack or batteries installed) to excessive heat such as sunshine, fire or the like for a long time. As the main plug is used to disconnect the unit from the mains, connect the unit to an easily accessible AC outlet. Should you notice an abnormality in the unit, disconnect the main plug from the AC outlet immediately. The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. [. . . ] Hand the battery over to the applicable collection point for the recycling of waste batteries. For more detailed information about recycling of this product or battery, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. AC power adaptor Note on the AC power adaptor Level 1 Level 2 Level 3 Level 4 To wall outlet When the battery becomes almost fully depleted, "LOW BATT" flashes and the unit will turn off. To charge the battery, connect the AC power adaptor. ( See "Preparing a power source. ") CAUTION Danger of explosion if battery is incorrectly replaced. Notice for customers: the following information is only applicable to equipment sold in countries applying EU directives The manufacturer of this product is Sony Corporation, 1-7-1 Konan Minato-ku Tokyo, 108-0075 Japan. The Authorized Representative for EMC and product safety is Sony Deutschland GmbH, Hedelfinger Strasse 61, 70327 Stuttgart, Germany. For any service or guarantee matters please refer to the addresses given in separate service or guarantee documents. AC power cord Notes · The remaining battery power will not be indicated when the unit is turned off. · The unit requires at least 30 minutes to charge the battery if "LOW BATT" appears. · The battery indicator shows approximate remaining battery power. · Operating conditions will affect the rate of battery depletion. 1 · Use the Sony supplied AC power adaptor only. 356. 0 mm × 162. 8 mm × 119. 7 mm (w/h/d) Mass Approx. 1. 9 kg Supplied accessories Remote commander (1) AC power adaptor (1) AC power cord (1) Audio connecting cable (1) Universal Dock Adapter for iPhone (1) Universal Dock Adapter for iPhone 3G & iPhone 3GS (1) Universal Dock Adapter for iPhone 4 (1) Design and specifications are subject to change without notice. Go to the next track Go back to the previous track Locate a point while listening to the sound Remote sensor 1 Connect the AUDIO IN jack on the back of the unit · The power off hold function may be set. In this case, cancel the power off hold function. (See "Power off hold function. ") · The rechargeable battery may be depleted. In this case, connect to the AC power adaptor to charge the battery. (See "Preparing a power source. ") The power will not turn on when the AC power adaptor is disconnected. to the line output jack of the portable digital music player or other component using an audio connecting cable. The buttons on the unit do not function. · When the unit is turned off, only the (power) button functions. Turn on the unit before operation. Display Locate a point while observing the display on iPod 2 Press (power) to turn on the unit. 4 Press FUNCTION repeatedly until "AUDIO IN" The rechargeable battery is depleted. There is no audio. · Adjust the VOL +/-. · Connect to the AC power adaptor to charge the battery. 2 Attach the adapter for your iPod/iPhone. Go back to the previous menu Select a menu item or a (up)/ (down) track for playback Execute the selected menu ENTER item or begin playback appears in the display. The sound from the connected component is output from the speakers of this unit. Noise is heard. · Ensure that the unit is not in the vicinity of in-use portable phones, etc. The display turns off. · If no operation is performed for more than 30 seconds, the display turns off. Press DISPLAY to turn on the display again. "ERROR" appears in the display and the unit turns off automatically. · If this symptom occurs frequently, consult your nearest Sony dealer. AUDIO IN DC IN 20V * During playback, this operation returns you to the beginning of the current track. [. . . ] 2 Press FUNCTION repeatedly until "iPod" appears in the display. Notes iPod classic Notes iPod 5th generation (video) iPod 4th generation (color display) Power off hold function You can set the power off hold function in order to avoid unintentional powering on while carrying the unit. To set the power off hold function Press and hold (power) when the AC power adaptor is disconnected. "HOLD" flashes 2 times and the display turns off. The unit cannot be turned on by pressing (power) while the power off hold function is set. · To use an iPod, refer to the user's guide of your iPod. · The connector of the unit is exclusively for use with an iPod. [. . . ]