User manual SONY RDP-NWD300

[. . . ] Precautions On safety AC cord must be changed only at the qualified service shop. Use only the supplied AC power adaptor. Do not use any other AC power adaptor. Polarity of the plug Identifying parts Main unit (See fig. ) / (power/standby) button / (power/standby) indicator LINE INPUT button LINE INPUT indicator PC MODE button PC MODE indicator*1 WM-PORT*2 plug (for connecting to "WALKMAN") (muting) indicator While muting the sound, the (muting) indicator lights up. [. . . ] The recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product. Applicable accessories: Active Speaker System Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) Rear Dimensions (w/h/d) Mass Operating temperature Supplied accessories This symbol on the battery or on the packaging indicates that the battery provided with this product shall not be treated as household waste. On certain batteries this symbol might be used in combination with a chemical symbol. The chemical symbols for mercury (Hg) or lead (Pb) are added if the battery contains more than 0. 0005% mercury or 0. 004% lead. By ensuring these batteries are disposed of correctly, you will help prevent potentially negative consequences for the environment and human health which could otherwise be caused by inappropriate waste handling of the battery. The recycling of the materials will help to conserve natural resources. In case of products that for safety, performance or data integrity reasons require a permanent connection with an incorporated battery, this battery should be replaced by qualified service staff only. To ensure that the battery will be treated properly, hand over the product at end-of-life to the applicable collection point for the recycling of electrical and electronic equipment. For all other batteries, please view the section on how to remove the battery from the product safely. Hand the battery over to the applicable collection point for the recycling of waste batteries. For more detailed information about recycling of this product or battery, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product. "WALKMAN" and the "WALKMAN" logo are registered trademarks of Sony Corporation. Disposal of waste batteries (applicable in the European Union and other European countries with separate collection systems) AC power adaptor (1) AC cord (1) Remote commander (1) Lithium battery CR2025 (1) (preinstalled for the trial use of the remote commander) Attachment for "WALKMAN" (2) Operating Instructions (1) Warranty card (1) Design and specifications are subject to change without notice. To the mains AC power adaptor (supplied) AC cord (supplied) To DC IN 13V jack Preparing the remote commander (See fig. ) Before using the remote commander for the first time, remove the insulation film. The battery is installed in the remote commander at the factory. Transferring data between a "WALKMAN" and a computer (See fig. ) By connecting a USB cable (supplied with the "WALKMAN") to a computer, you can transfer data between a "WALKMAN" set on the WM-PORT plug and the computer. 1 Press the / button to turn on the main unit. Press the PC MODE button until the PC MODE indicator lights up. Transfer data between the "WALKMAN" and computer. For details about transferring data, refer to the Operation Guide of the "WALKMAN. " When transferring data is finished and you want to start playback, press the PC MODE button until the PC MODE indicator turns off. 1 2 Lithium battery CR2025 (not supplied) Replacing the lithium battery (See fig. ) The working distance of the remote commander shortens as the battery becomes exhausted. Replace the battery with a new one following the procedure below. It will last about 6 months normally. 2 3 1 2 3 Take out the battery case. -1) Replace the lithium battery CR2025 with a new one, with the + side facing up. [. . . ] Make sure the "WALKMAN" is playing music. Press the PC MODE button until the PC MODE indicator turns off. Press MUTING on the remote commander to set MUTING to OFF. If the approaches listed above fail to resolve the issue, press the RESET button of the "WALKMAN" to reset it. The remote commander does not function on the main unit or the "WALKMAN. " Bring the remote commander close to the remote sensor of the main unit. [. . . ]