User manual SONY RDR-HX1025

[. . . ] The CLASS 1 LASER PRODUCT MARKING is located on the laser protective housing inside the enclosure. Notice for customers in the United Kingdom and Republic of Ireland A molded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS1362, (i. e. , marked with or mark) must be used. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover. [. . . ] Select "OK, " and press ENTER. To scroll the list display by page (Page mode) Press / while the list display is turned on. Each time you press / , the entire Timer List changes to the next/previous page of timer settings. To turn off the Timer List Press TIMER LIST or O RETURN. "Check Overlap": Checks for overlapped settings. The timer setting without the mark has priority over the other settings. z Hint While recording, you cannot modify the timer setting for the current recording, but you can extend the duration of the recording time (page 39). b Notes · When "PDC/VPS" is set to "On" for one or more timer recordings, the start times may change in the event of a broadcast delay or early start. · Even if the timer is set, timer recordings cannot be made while recording a programme that has priority. · Even if the timer is set for the same daily or weekly programme, the timer recording cannot be made if it overlaps with a programme that has priority. " " will appear next to the overlapped setting in the Timer List. Check the priority order of the settings. Select "Close" to return to the Timer List. To change or cancel the setting, repeat steps 2 and 3 above. 43 Recording From Connected Equipment +RW +R 4 5 Set the timer on the connected equipment to the time of the programme you want to record, and turn it off. Press c z SYNCHRO REC. The SYNCHRO REC indicator lights up on the front panel. The recorder is ready to start Synchro-Recording. When you start playing a VIDEO CD with PBC functions, the menu appears. Select an item using the number buttons and press ENTER. Then, follow the instructions in the menu (press H when "Press SELECT" appears). The PBC function of Super VIDEO CDs does not work with this recorder. Super VIDEO CDs are played in continuous play mode only. / </M/m/, , ENTER OPTIONS . H X > x To change the angles 1 2 Insert a disc. · See "1. · If you insert a DVD VIDEO, VIDEO CD, or CD, press H. Playback starts. If various angles (multi-angles) for a scene are recorded on the disc, " " appears in the front panel display. Press OPTIONS during playback to select "Change Angle, " and press ENTER. Press TITLE LIST. For details about the Title List, see "3. Playing the Recorded Programme (Title List)" on page 28. Example: DVD+RW To stop playback Press x. 46 To resume playback from the point where you stopped (Resume Play) When you press H again after you stop playback, the recorder resumes playback from the point where you pressed x. To start from the beginning, press OPTIONS to select "Play Beginning, " and press ENTER. [. . . ] In this case, check the following table. First three Cause and/or corrective characters of action the service number C 13 The DVD is dirty. , Re-insert the disc correctly. "RECOVERY" appears in the front panel display. , The recorder's recovery function was activated when the recorder was turned on because the power was turned off or failed during recording. Leave the recorder on until "RECOVERY" disappears from the front panel display. C 31 "FAN ERROR" appears in the front panel display. , Check that the vent on the rear of the recorder is not blocked. Then, immediately disconnect the mains lead. [. . . ]