User manual SONY RM-AV1100A

[. . . ] Besides distributing video signals wirelessly , the Wireless TV Link also functions as a switch box for your main TV. it is equipped with four SCART input connectors. These allow you to connect up to four video devices at the same time, so cable swapping or re-configuring your audio/video set-up is no longer necessary. In addition, three of the SCART inputs can be linked to the fourth one, which makes copying your video content very simple. [. . . ] When the receiver unit is turned on, the transmitter unit switches on automatically and TV2 displays the signal on its SCART input. Have a second person check that the power light (A-1) on the transmitter unit flashes. This indicates that it is receiving the remote control signal from the receiver unit. If the power light (A-1) does not flash, reposition the remote control antenna at the rear of either unit (A-18 or B-28). The power light on the transmitter unit should now flash when a remote control command is given at the receiver side. If the video source does not respond to the remote command, try realigning the front of the transmitter unit with the front of the video source until you get a response. Press the ­ or + buttons (B-22) on the receiver unit to select the video source to be displayed (or use the universal remote control unit*). the selection cycle is SCART input 1> 2 > 3 > 4 Aim the remote control at the receiver unit to control the video source. Use either video source's remote control or, even better, the universal remote control after selecting the correct mode*. The VCR (or DVD+RW) must be connected to the cable TV network and to the transmitter unit of the Wireless TV Link. Some VCRs need to be switched to tuner mode to remain on (refer to their instructions for use). Press power button (A-1) to switch transmitter unit on. Power light (A-2) is green; AUTO light (A-7) is off (automatic switching is disabled). Select the EXT or AV input of TV1 to which the transmitter unit is connected (see TV instruction manual). The Universal Remote Control is capable of controlling the receiver or transmitter unit and up to five additional devices. With this single unit you can control all your devices remotely, regardless of their brand. Select the LINK mode with the mode selector to operate the receiver or transmitter unit remotely. the red indicator under LINK lights up. The LINK mode does not require any form of set-up and can be used straight away. Point the universal remote control at the transmitter unit and press the channel up/down or numerical keys 1 to 4 to select the SCART input for viewing on TV1. Pressing the power button turns the transmitter on or off. Point the universal remote control at the receiver unit and press the channel up/ down or numerical keys 1 to 4 to select the video source for viewing on TV2. [. . . ] Move the transmitter unit around gently until the buzzing sound stops. With some types of TV you will not be able to solve this problem. Switch to another frequency channel on both units. DVD player gives no pictures on either TV1 or TV2. [. . . ]