User manual SONY RM-AV2100T

[. . . ] The RM-AV2100T Remote Commander provides centralised control of all your AV components from a single remote commander and saves the trouble of operating different AV components with different remote control devices. Centralised control of Sony AV components with this one remote commander This Commander is preset at the factory to operate Sony brand components, so you can use it out of the box as a control centre for your Sony AV components. You can remote control your components by setting their code numbers (page 8). Learning function for programming other remote control signals you need This Commander has a learning function, to learn remote control signals to operate non-preset components or functions (page 16). [. . . ] In this case, clear the programme and start again from Step 1 to set the entire programme from the beginning. You can not continue from where you let off. ⷠIf you change the component code number (page 8) or programme a new signal by learning (page 16) for a key or button that has been programmed with the series of commands of a System Control function, the new signal will be transmitted when you press the corresponding Component Select button. When the contents of its programme are cleared, "VCR3" stays lit, and the other component names flash. When you want to set a new programme to this Component Select button, follow Steps 1 to 2 on page 28. CONTROL buttons (1, 2, or 3) or the Component Select button whose interval you want to change. The number of the current setting stays lit and other numbers flash. The selected number stays lit and other numbers flash. When using Sony components, you can programme the Power-on signal for each component on a Component Select button. You can select the desired component and power it on by just pressing that Component Select button. When the Power-on command is programmed, you will hear a beep and "1 ON" appears on the display. (The display goes off when you release the buttons. To clear the Power-on command Even if you have programmed a signal by "learning" (See "Adding a command that is required when selecting a component. ") or a System Control function (page 28) for a Component Select button, you can programme the Power-On function for that button, but it cannot be used. If you clear a "learned" signal or the System Control function from the button, you can use the Power-On function. ⷠYou can programme a signal by "learning" (page 32) or a System Control function (page 28) for a Component Select button for which the Power-On function has been programmed. In this case, the Power-On function is overwritten and cannot be used. If you clear the "learned" signal or the System Control function from the button, the PowerOn function is resumed, and you can use it again. If you have programmed both a signal by "learning" and a System Control function for the button, the "learned" signal will have overwritten the System Control function. Adding a command that is required when selecting a component In addition to the original function of selecting the operating keys and buttons of the desired component, the Component Select button can have another remote control signal by "learning. " For example, if you always have to change input select of the amplifier to CD when listening to the CD player, programme the signal of "changing the amplifier's input select" to the CD button of this Commander. Then whenever you press the CD button, it automatically works as the original CD Component Select button and changes also the amplifier input select to CD. [. . . ] to select a number between 20 and 29 Fastext buttons 2 +/­ % To operate JUMP function on the TV depending on the setting of the TV's manufacturer Volume up: + Volume down: ­ To mute the volume on the TV. With Fastext you can access pages with one key stroke. When a Fastext page is broadcast, a colour-coded menu will appear at the bottom of the screen. The colours of this menu correspond to the red, green, yellow and blue keys on the Remote Commander. [. . . ]