User manual SONY RM-PP412

[. . . ] This chapter provides information on the location of buttons and how to use them to perform basic operations. However, some functions explained in this section may not work depending on the model of the receiver. For the functions of the receiver you purchased, refer to the Operating Instructions supplied with the receiver. Press to change remote key function to activate those buttons with orange printing. [. . . ] After pressing MAIN MENU, AV MENU, or TOP MENU/GUIDE, press to return to the previous menu or exit the menu. Press to turn the sound field off and listen to 2 channel stereo sound. When you selected CD player, video CD player, LD player, MD deck, or tape deck, press to select track number over 10. When you selected TV, press to select the channel entry mode, either one or two digit. Some buttons may not be used depending on the model. â· The above explanation is intended to serve as an example only. Therefore, depending on the component the above operation may not be possible or may operate differently than described. â· To activate the buttons with orange printing, press ALT first before pressing the buttons. To operate other components, press TOP MENU/ GUIDE or AV MENU after selecting the input. After pressing MAIN MENU, AV MENU, or TOP MENU/GUIDE, use the button to make specific settings, then press the button to enter the selection. (Press to start play on the front sides of the cassette. Press to pause play or recording, or press to start recording when the component is in recording standby. Press to search tracks in the forward or backward direction. The function of these buttons switch automatically each time you select the input (2). Depending on the component, the above operation may not be possible or may operate differently than described. Table of buttons used to control each component When you program the remote to control the following Sony or non-Sony components, you can use the buttons on the remote that are marked with circles. Note, however, that some buttons may not operate your component. Component CD player DAT deck MD deck Tape LD deck player (A and B) VCR TV Satellite Video tuner/ CD Cable player box DVD player This chapter describes how to set the remote to control non-Sony components. Repeat steps 1 to 4 to control other components. Once the control signals have been memorized, you can use those components as part of your system. [. . . ] The USE MODE button lights once (or twice for AV2), then the command mode switches. The USE MODE button lights 3 times, then goes off. If you experience any of the following difficulties while using the receiver, use this troubleshooting guide to help you remedy the problem. Should any problem persist, consult your nearest Sony dealer. [. . . ]