User manual SONY RM-V15

[. . . ] If the Commander seems to be working properly, you're done setting up the Commander. Make sure that the slide switch is set to the component you want to operate. Do not mix old batteries with new ones or mix different types of batteries together. ⷠIf you take time to insert the batteries or press the buttons when replacing the batteries, the code numbers will be erased. [. . . ] To prevent the electrolyte from leaking, remove the batteries when you plan not to use the Commander for a long period of time. The instructions in this manual are for RM-V15 and RM-V21T. Before you start reading, check your model number. rM-V21T is the model used for illustration purposes. Any differences in operation are clearly indicated in the text, for example, RM-V21T only. With Fastext you can access pages with one key stroke. When a Fastext page is broadcast, a colour-coded menu will appear at the bottom of the screen. The colours of this menu correspond to the red, green, yellow and blue buttons on the Remote Commander. Using this Commander will not increase the functions of your TV, VCR or satellite tuner. the functions of the Commander are limited to the functions of the TV , VCR or satellite tuner itself. If the code that's listed first for your component doesn't work, try all the codes for your component -- in the order in which they're listed. If all the codes fail to work (or if your component is not listed in this manual), try using the procedures under "Searching for the Correct Code". ⷠCheck that you're aiming the Commander directly at the component, and that there are no obstructions between the Commander and the component. ⷠMake sure the batteries you're using are not worn out, and that they're inserted correctly. Note that whenever you remove the batteries -- to replace them, for example -- the code numbers you've set are automatically erased and must be reset. If you have any questions or problems concerning the Remote Commander that are not covered in this manual, please call the telephone number in the warranty. 5 Rewind 6 Play 7 Record To record, press ( while pressing r 8 To switch to VCR, AUX, satellite tuner or TV operation. (The light will automatically turn off if no button is pressed for more than 10 seconds. For example, if you're entering the code for a Philip's TV, you would press and release 1, then press and release 1. The Commander can be set up to operate only one component of each category (VCR, AUX, SAT or TV position of the slide switch) at a time -- unless their code numbers happen to be the same. [. . . ] The Commander can be set up to operate only one component of each category (VCR, AUX, SAT or TV position of the slide switch) at a time -- unless their code numbers happen to be the same. For example, you cannot set up the Commander to operate a Sony TV and a Panasonic TV at the same time (because they use different code numbers). Enter the component's code number in the same way as after step 4 of "Entering the Code Number", or after step 3 of "Searching for the Correct Code". Be sure to line up the + and ­ on the batteries with the + and ­ on the battery compartment. [. . . ]