User manual SONY RM-V201T

[. . . ] Works in the same way as your TV's commander. You can set up this Remote Commander to operate the following components of almost all major brands including Sony. [. . . ] If all the codes fail to work (or if your component is not listed), try using the procedures under "Setting by Searching for the Correct Code". Check that you're aiming the Commander directly at the component, and that there are no obstructions between the Commander and the component. Make sure the batteries you're using are not worn out, and that they're inserted correctly. If you cannot preset a component to the AUX or SAT position of the slide switch, a component type different from that of the component you intend to preset may be assigned to that position. For example, if your component didn't come with a remote control, it probably isn't capable of being controlled by the Remote Commander. Should any problem persist, reset the Commander to the factory setting by pressing the u, . and Á­ buttons simultaneously. If you have any questions or problems concerning the Remote Commander that are not covered in this manual, please call the telephone number in the warranty. If the component does not operate properly, repeat steps 3 to 6 and search for another code. If you still cannot get the Commander to work properly, see "Troubleshooting". note Be sure to proceed to each next step in the above procedure within 10 seconds; otherwise setting mode will be canceled. Work in the same way as your satellite tuner's commander. [. . . ] Enter the component's code number by following steps 2 to 5 of "Setting by Entering the Code Number", or steps 3 to 7 of "Setting by Searching for the Correct Code". Works in the same way as your VCR's commander. [. . . ]