User manual SONY RM-V21

[. . . ] This Commander is preset for most major brands components other than Sony. You can control your components remotely by setting their code numbers (page 13). Learning function for programming other remote control signals you need Components are selectable with 12 keys on the LCD display by pressing the Label Select buttons. This Commander has an LCD display that changes the label display according to the selected component. [. . . ] In this case, check the operating component's power on/off state before using the system control function. In Step 5 (page 35), while pressing the Label Select button corresponding to the label that you want to erase, press the SCROLL button. (The labels for which the System Macro is programmed stay lit. ) "CLEAR OK" appears and the System Macro is cleared with a beep sound. The cleared label flashes together with other labels which have no System Macro data. If the character contents of the label have been changed To clear the character contents of that label, perform the same procedure above again. The overwritten System Macro is cleared when you perform the procedure above and the factory presetting returns to the SONY OFF label. If the character contents of the SONY OFF label have been changed, the character contents are cleared when you perform the procedure above again. When you select the label for which the System Macro is programmed, the `NG' sound is heard. If you release the Label Select button then, data is not cleared and the System Macro signal is transmitted. To clear programmed commands for a specific System Macro number label You can clear the System Macro and the character contents you have programmed for a label. You can copy the entire settings of a component label. The settings of the component code (page 13), the channel macro function (page 48), the learned functions (page 23), component macro function (page 40), Power-On command (page 44) and character contents are copied to a new label. You cannot copy the settings to a component label for which any learned function, channel macro function or component macro function has been programmed. The character contents are overwritten over a new label. Which the contents are to be moved by pressing the Label Select button. If you select a Component label for which any channel macro, learning, component macro function has been programmed "NG" appears and the `NG' sound is heard twice. Follow the steps in "To clear the contents programmed for a specific component label", page 19. Which the contents are to be moved by pressing the Label Select button. With a beep sound, the copying finishes. -- Channel Macro Function You can programme the Channel Macro function of the components of which the first digit of the fourdigit preset component code number is 3 (SAT1 and SAT2) or 8 (TV). And you can programme the Channel Macro function for the macro labels for a component again to send data. [. . . ] The component could not receive the signal from the operated by the timer of Commander successfully. When using the timer, check the the Commander does not following. - Check that the timer macro programme functions correctly by pressing the TEST key, after programming the timer (page 58). The status of each component is not suitable for operation. [. . . ]