User manual SONY RM-V210T

[. . . ] 6 Enter the component's code number by following steps 2 to 6 of "Entering the Code Number", or steps 1 to 7 of "Searching for the Correct Code. " You can control the volume of the receiver (or amplifier) of the RCVR button while selecting any component. For example, to program t t ENT on the N button, hold down N first, press , , and ENT in sequence, and then release N. ) 8 To move the cursor upward, downward, to the left, or to the right. [. . . ] Q; To record, press N while pressing zREC. Qj To clear the selected characters from the screen. For example, to select track 15, press PIP and then press 5. 6 To change the display mode or turn the display on/off. Q; To record, press N while pressing zREC/First release N, then release zREC. To select track numbers above 10, see the descriptions on the PIP button above. When you want to change the setting or if you are no longer using that programmed operation, follow the procedure below to overwrite or clear the program. 1 Hold down the macro key that you want to change or clear. 2 After waiting for about three seconds, press the new sequence of buttons, or, to clear the program, press and release , and then press and release ENT. In step 3 above, press VOL­ instead. 8 To move the cursor upward, downward, to the left, or to the right. If the volume on the cable box is turned down completely, you will not be able to adjust your TV's volume with the Commander. ⷠDo not take more than 3 minutes to replace the batteries; otherwise, your setting of the code numbers will be erased. If you have problems setting up or using the Commander: · When setting up the Commander, carefully go through the procedures described in "Setting the Code. " If the code that's listed first for your component doesn't work, try all the codes for your component - in the order in which they're listed. If all the codes fail to work (or if your component is not listed in this manual), try using the procedures in "Searching for the Correct Code. " · Check that you're aiming the Commander directly at the component, and that there are no obstructions between the Commander and the component. ⷠMake sure the batteries you're using are not worn out, and that they're inserted correctly. For example, if your component didn't come with a remote commander, it probably isn't capable of being controlled by a remote commander. ⷠIf your video components are connected to an audio system, make sure you've set up the Commander as described in "Controlling the Volume of Video Components Connected to an Audio System. " · Should any problem persist, reset the Commander to the factory setting by pressing the POWER, TV/VIDEO and VOL­ buttons simultaneously. Basically, use this Commander in the same way as the Commanders supplied with your components. [. . . ] For example, if you're setting up a Philips' VCR, you would use the code number 035. If your component isn't listed, see "Searching for the Correct Code. Thus you can control the volume of your TV or receiver (or amplifier) while operating a video or audio component without first having to press the TV or RCVR button. For example, to control the volume for your VCR channels, you don't need to press the TV button first. [. . . ]