User manual SONY RM-V211T

[. . . ] Aim the Commander to your component, and press and release the PROGR+ button. Repeat step 4 until the correct code number is found. [. . . ] If you have any questions or problems concerning the Remote Commander that are not covered in this manual, please call the telephone number in the warranty. When the correct code is found, press the t button. Turn on the component again, and check that the Commander can control the other functions of your component such as channel and volume control. Be sure to line up the + and ­ on the batteries with the + and ­ on the battery compartment. If the component does not operate properly, repeat steps 2 to 6 and search for another code. If you still cannot get the Commander to work properly, see "Troubleshooting". Works in the same way as your TV's commander or VCR's commander. ZREC: To record, press N while pressing z. Be sure to proceed to each next step in the above procedure within 10 seconds; otherwise setting mode will be canceled. When you have two or more components of the same type (for example, three VCRs), you can change the component's type on DVD button and SAT button. If the Remote Commander does not operate properly, the batteries might be worn out. ⷠDo not take more than 20 minutes to replace the batteries; otherwise, your setting of the code numbers will be erased. Enter the component's code number by following steps 1 to 5 of "Setting by Entering the Code Number", or steps 2 to 7 of "Setting by Searching for the Correct Code". Aim this Commander to your component and check if you can operate it using this Commander. [. . . ] the functions of the Commander are limited to the functions of the component itself. For example, if your TV does not have a mute function, the % button on this Commander will not function with your TV. [. . . ]