User manual SONY RM-V302T

[. . . ] Even if you try to program more than four operations and press the corresponding buttons in step 2 above, only the first four buttons that were pressed will be programmed. If you try to program only one operation on a macro key, the setting operation will be rejected. You can program the Channel Macro function for up to three components only. To program a fourth component, first clear all macro keys for a component. [. . . ] The Commander is factory preset based on the assumption that you hear the sound of your video components from your TV's speakers, and that you hear the sound of your audio components from the loudspeakers connected to your amplifier (or receiver). Be sure to wait for about three seconds in step 2 above. While you are holding down the macro key and waiting, the programmed signals are transmitted; therefore, if you are aiming the Commander at your component, the programmed operations may be performed before you go on with the procedure. The Commander can be set up to operate only one component per button ­ unless their code numbers happen to be the same. For example, you cannot set up the Commander to operate a Sony TV and a Panasonic TV simultaneously (because they use different code numbers). You may not be able to operate even a Sony brand component with the factory presetting. Basically, use this Commander in the same way as the Commanders supplied with your components. Using this Commander will not increase the functions of your components. the functions of the Commander are limited to the functions of the components themselves. For example, if your TV does not have a MUTING function, the % button on this Commander will not function with your TV. Some functions of the component may not work with this Commander. 4 Repeat step 3 until the correct code number is found. Each time you press the PROGR+ button and then the 1 button, a new code number will be transmitted. Keep trying until your component operates as follows: · TV without a power switch: the Channel + function works. Be patient as you do this; it could take as many as 120 tries before the correct code number is located. 5 When the correct code is found, press the t button to store the code number in the Commander's memory. 6 Check that the Commander is operating the other functions of your component by pressing the corresponding buttons on the Commander. If they seem to be working properly, you are done setting up the Commander. If the component does not operate properly, repeat steps 1 to 5 and search for another code. If you still cannot get the Commander to work properly, see "Troubleshooting. If you have problems setting up or using the Commander: · When setting up the Commander, carefully go through the procedures described in "Setting the Code. " If the code that is listed first for your component does not work, try other codes for that component in the order in which they are listed. [. . . ] If you press a wrong button in step 4 Press the 1 button while pressing the S (SET) button and then go back to step 2. This feature is effective only when an amplifier (or receiver) is set up on the AMP button. You cannot control the volume of an amplifier (or receiver) set up on VCR, SAT or DVD button while operating the component of another button. If you have any questions or problems concerning the Remote Commander that are not covered in this manual, please call the customer remote helpline. [. . . ]