User manual SONY RM-V70T

[. . . ] Each time you press the PROGR+ button and then the u button, a new code number will be transmitted. Keep trying until your component operates as follows: · CD player (whose power cannnot be turned off using the remote commander): playback starts. (Make sure that the power is already turned on and that a disc is inserted. ) · TV without a power switch: the Channel + function works. [. . . ] For example, to control the volume for your VCR channels, you don't need to change the slide switch from VCR to TV. However, if your video components are connected to an audio system, you probably hear your TV's or VCR's sound from the loudspeakers via your amplifier (or receiver), not from your TV speakers. In this case, you need to change the factory setting so that you can control the volume of your video components without first having to switch to the amplifier (or receiver). To change the factory setting for the volume control, follow the procedures below. Works in the same way as the TV's commander. To return from Teletext to TV To select a number between 20 and 29. 7 m (23 ft) (varies depending on the component of each manufacturer) Power requirements Two R6 (size AA) batteries (not supplied) Battery life Approx. ) (not including batteries) Supplied accessory Label (1) Design and specifications are subject to change without notice. If you're having problems setting up or using the Remote Commander: · When setting up the Commander, carefully go through the procedures described under "Setting the Code". If the code that's listed first for your component doesn't work, try all the codes for your component -- in the order in which they're listed. If all the codes fail to work (or if your component is not listed in this manual), try using the procedures under "Searching for the Correct Code". Check that you're aiming the Commander directly at the component, and that there are no obstructions between the Commander and the component. Make sure the batteries you're using are not worn out, and that they're inserted correctly. If you cannot preset a component to the SAT/AUX, AMP or CD position of the slide switch, a component type different from that of the component you intend to preset may be preset to that position. In such a case, enter the code number first, following the procedure in "Entering the Code Number for Another TV, VCR, Amplifier (or receiver), CD Player or Satellite tuner". For example, if your component didn't come with a remote control, it probably isn't capable of being controlled by the Remote Commander. If your video components are connected to an audio system, make sure you've set up the Commander as described in "Controlling the Volume of Video Components Connected to an Audio System". Should any problem persist, reset the Commander to the factory setting by pressing the u, . [. . . ] If you're setting up another component, you'll need to complete the procedure above for each component you plan to use with the Commander. Use the label (supplied) to write down the code numbers of your components. Then affix the label to the back of the Commander. note The Commander can be set up to operate only one component of each category (VCR, AMP, CD, SAT/AUX or TV position of the slide switch) at a time -- unless their code numbers happen to be the same. [. . . ]