User manual SONY RM-V80T

[. . . ] This setting is effective also if you set other visual components in the AUX1/AUX2 or SAT/TAPE position. However, you cannot change the volume control of audio components. You can perform this operation either before or after you set up the Commander to work with your component. 2 To select the input source: 1 switches to VIDEO 1 2 switches to VIDEO 2 3 switches to AUX 4 switches to TUNER 5 switches to CD 6 switches to TAPE 1 7 switches to TAPE 2 8 switches to TV 9 switches to PHONO 0 switches to another input source by each pressing 3 Volume up: + Volume down: ­ 4 To mute volume on an amplifier (or receiver). [. . . ] When the correct code is found, press and release the . button to store the code PROGR number in the Commander's memory. Turn on the component again, and press the PROGR and Á buttons. Check that the Commander can control the other functions of your component such as channel and volume control. Press and release one of the following buttons; 1 to set up a VCR 4 to set up an amplifier (or receiver) 5 to set up a CD player 6 to set up a tape deck 7 to set up a MD deck 8 to set up a TV 9 to set up a satellite tuner Note A To control the component's sound from the loudspeakers connected to your amplifier (or receiver), press the Á+ button. If you haven't already done so, finish setting up the component by completing the procedures in "Entering the Code Number". Be sure to proceed to each next step in the above procedure within 10 seconds; otherwise setting mode will be canceled. You can set another component on the SAT and TAPE positions as well as the AUX1 and AUX 2 positions. Works in the same way as the TV's commander. To return from Teletext to TV To select a number between 20 and 29. Make sure that the VISUAL/AUDIO selector and the slide switch are set for the component you wish to operate. Enter the component's code number by following steps 4 to 6 of "Entering the Code Number", or steps 2 to 6 of "Searching for the Correct Code". Work in the same way as the satellite tuner's commander. (The other numeric buttons do not have assigned functions). The Commander is factory preset based on the assumption that you hear the sound of your video components from your TV's speakers, and that you hear the sound of your audio components from the loudspeakers connected to your amplifier (or receiver). With Fastext you can access pages with one key stroke. When a Fastext page is broadcast, a colour-coded menu will appear at the bottom of the screen. The colours of this menu correspond to the red, green, yellow and blue buttons on the Remote Commander. Using this Commander will not add new functions to your components. the functions of the Commander are limited to the functions of the components itself. For example, if your TV does not have a mute function, the ¤ button on this Commander will not function with your TV. Do not forcibly remove or tear off the corner protector. [. . . ] note Be sure to proceed to each next step in the above procedure within 10 seconds; otherwise setting mode will be canceled. First, try repeating these setup procedures using the other codes listed for your component (see "Component Code Numbers"). If -- after trying all the codes listed for your component -- you still cannot get the Commander to work properly, try the search method described under "Searching for the Correct Code". Thus you can control the volume of your TV or amplifier (or receiver) while operating a video or audio component without first having to change the slide switch to the TV or AMP position. [. . . ]