User manual SONY RM-VL600T

[. . . ] Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. the recycling of materials will help to conserve natural resources. [. . . ] All Component Select buttons light up when you press these buttons, and then turn off when you release them. Visual components are: TV, video cassette recorder, analogue cable box, satellite tuner, DVD player Audio components are: CD player, MD player, cassette deck, amplifier To cancel setting, press SET. note If you used the Learning function to programme the 2 +/­ or % buttons to send a signal to a component, the procedure above will not change the function of the 2 +/­ and % buttons. When a code number of a Sony component is set to a Component Select button, the Power-On signal is automatically programmed to the button. You can select the desired component and power it on by just pressing that Component Select button. Example: To clear the Power-on command While the 1 button is pressed, the Component Select buttons that Sony components are set to flash in the following order. TVtDVDtSATtCBLt VCRtCDtTAPEtAMP The Component Select buttons that Sony components are not set to do not flash. If you change the component code (page 10) after setting the Power-On function, the Power-On function is cleared. (The Component Select button flashes twice to indicate that you cannot set this function. ) · Even if you used the Learning function (page 16) to programme a signal on a Component Select button, you can programme the Power-On function on that button but it cannot be used. If you clear the "learned" function on that button, you can use the Power-On function. With the System Control function, you can programme a series of operating commands, and execute them by pressing just one button. You can programme up to 16 consecutive operation steps to each of the SYSTEM CONTROL buttons (A ­ D). If you have set the System Control function for a Component Select button (page 32), the execution of the programmed commands begins when you press the Component Select button for more than 2 seconds. When executing the programmed commands, each remote commander signal is transmitted. Example: To watch a video, you can set a series of operations as follows: To programme a new series of operations for those buttons which already have a Control Programme set If you interrupt the procedure at any point for over 20 seconds, the setting mode ends and the series of commands will be programmed up to that point. In this case, clear the programme (page 31) and start again from Step 1 to set the entire programme from the beginning. You cannot continue programming once the setting mode ends. If a SYSTEM CONTROL button has already "learned" a remote control signal (page 16), you can programme a System Control function (System Control Macro), but the function will not work until you clear the Learning function. If you change the component code number (page 10) or programme a new signal by using the Learning function (page 16) on a key or a button that has been programmed with a series of commands using the System Control function, the new signal will be transmitted when you press the corresponding SYSTEM CONTROL button. While in setting mode, you cannot clear any operation step you have programmed. If you have programmed an incorrect operation by mistake, start again from Step 1. [. . . ] To record, press N while pressing REC z *. * In order to avoid recording by mistake, the REC z button does not work by itself. With Fastext you can access pages with one key stroke. When a Fastext page is broadcast, a colour-coded menu will appear at the bottom of the screen. [. . . ]