User manual SONY RM-VL900T

[. . . ] For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product. The RM-VL900T Remote Commander provides centralized control of all your A/V components from a single Remote Commander and saves the trouble of operating different A/V components with different remote control devices. Up to 10 series of commands (Component Macros) which provide up to 32 consecutive steps by pressing a single button can be set. With the Remote Commander, you can control up to 10 components, including your TV, VCR, SAT, DVD, AMP, CD, etc. [. . . ] Press the V/v buttons so that the position of the delay appears in the third line on the screen, then press the SCROLL button. Delay is added between the second line and the third line on the screen, and "[DELAY]" appears in the third line on the screen. If a number is displayed before the menu, you can select the menu by pressing the number button. While pressing the COMPONENT select button or Label select button on which the Component Macro has been programmed, press the (light) button. If remote sensors of A/V components are too far apart from each other, or they are covered, consecutive operation steps programmed on a Component Macro may not be executed. If a Component Macro is not executed properly for any reason, such as mentioned above, be sure to set all the A/V components to the status before the Component Macro was executed. Otherwise, A/V components will not work properly next time the Component Macro is executed. Because some A/V components are designed to turn on/off each time they receive the power on/off signal, those components may not be turned on with the Component Macro. Check the power on/off status of the A/V components before using the Component Macro. You can set A/V components to turn on when they are selected. This function is effective only for Sony components. If a number is displayed before the menu, you can select the menu by pressing the number button. The button illumination is preset at the factory to turn off automatically if you do not operate within 10 seconds. You can also change the brightness and fade effect (which adjusts the brightness of the button illumination) of the button illumination and which buttons activate the button illumination. You can set the automatic-off time from 1 to 60 seconds. Note If you set the automatic-off time to longer than 10 seconds, the battery life may be shorter. If a number is displayed before the menu, you can select the menu by pressing the number button. If a number is displayed before the menu, you can select the menu by pressing the number button. You can set the brightness from 1 to 15. Each time the button is pressed, the level decreases/increases by 1. If a number is displayed before the menu, you can select the menu by pressing the number button. If a number is displayed before the menu, you can select the menu by pressing the number button. [. . . ] Perform the next step within 60 seconds. A confirmation beep sounds during set mode, even if the beep sound is set to off. If "E" appears on the screen, the Remote Commander cannot enter into the set mode. The confirmation beep sounds even though beep sound is set to off. [. . . ]