User manual SONY RM-VLZ620

[. . . ] 4-170-639-12(1) Integrated Remote Commander Operating Instructions RM-VLZ620 ©2010 SonyCorporation For the customers in the U. S. A. WARNING This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] The SET indicator turns off. To clear a programmed procedure 1 Press and hold SET for more than 3 seconds. Press and hold the programmed button you want to reset for more than 3 seconds. When the programmed procedure is cleared, the SET indicator flashes three times and turns off. 0 Locking the Controls (Hold Function) To prevent accidental operation, you can lock all the buttons with the Hold function. It is recommended to use this function to prevent children from misoperating devices such as air conditioners. SET/SET indicator POWER 1 PressandholdSETformore than3seconds. TheSET indicator lightsup. 2 WhilekeepingSETheld Additional Features down, pressPOWER, then , andreleasethreebuttonsat thesametime. The SET indicator flashes three times and turns off. 3flashes The hold function is set. While all the buttons are locked, no function can be operated. If you press any key except SET, the SET indicator will flash three times. To unlock the controls 1 Press and hold SET for more than 3 seconds. 2 While keeping SET held down, press POWER, then RETURN, and release three buttons at the same time. The SET indicator flashes three times and turns off. All the buttons will be unlocked. 1 Restoring the Factory Settings You can clear all the settings (manufacturer's codes, learned functions, and programmed consecutive procedures), and reset the RM-VLZ620 to its factory settings. If you want to clear the settings for any Device Select button, see page 14. SET/SET indicator 1 PressandholdSETformore than3seconds. WhilekeepingSETheld down, press , thenrelease bothbuttons. TheSETindicator lightsup. 2 Enter - 0 - 0. The Device Select buttons start flashing in sequence. If you want to clear all the settings, go to Step 3. The SET indicator flashes once and turns off. 3 Press . , 0 When all the settings have been cleared, the SET indicator flashes three times and turns off. 3flashes 2 Other Information Precautions Do not drop the unit or give a shock to the unit, or it may cause a malfunction. Do not leave the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or sand, moisture, rain or mechanical shock. Do not put foreign objects into the unit. Should any liquid or solid object fall into the unit, have it checked by qualified personnel before operating the unit any further. Do not expose the remote control detectors of your devices to direct sunlight or other strong illumination. Too much light there can interfere with remote control operations. Place the remote control out of the reach of small children or pets. Devices such as air conditioners, heaters, electric appliances, and electric shutters or curtains receiving an infrared signal can be dangerous if misused. Specifications Operating distance Approx. [. . . ] Refer to its instruction manual for details. 2 CD button The buttons operate as below in the factory preset mode. Cassette deck KEY DISPLAY FUNCTION Rewinds. Turn the amplifier's volume up/down. DECK A/B Switches between deck A and deck B (dual cassette deck only). Enables the Sleep function (when available). CD player KEY DISPLAY /// VOL +/­ INPUT 1 ­ 9, 0 (dot) POWER INFO MUTING SLEEP ENTER FUNCTION Opens/closes the disc tray. [. . . ]